Your cart is empty.
Your cart is empty. Description
This item is manufactured with for durable and long alsting use. Equipped with two connectors, it is compatible with many stepper models. Great tool for providing connection use for the machine.
Feature
- Color: As shown.
- Material: Plastic.
- Size: About 100 * 0.5 * 0.2cm/39.37 * 0.2 * 0.09inch(L*W*H).
- Made of material, it is durable and long lasting use.
- It is compatible with many stepper models.
- Equipped with two connectors.
- 4 pin connector of the driver side, compatible with RAMPS board and other.
Package Including
4 * 1M Stepper Motor Cables Wire HX2.54 4 pin to 6 pin
n l.
Reviewed in the United States on March 9, 2022
used to change my 3d printer to direct drive setup, length is perfect for my ender 3NOTE the wires on my original connector were different and i had to change 2 of them around on one end. this was easily done with a small pick and only took a few minutes but was necessary to make it work correctly.
Chris Cox
Reviewed in the United States on February 14, 2022
Have yet to test the product. However instead of 4 pieces I have 2 pieces. I can only think that this is a cost saving measure where 8 wire ribbon may be cheaper than 4 wire ribbon. This is inaccurate to the picture in the listing. Perhaps in the factory these double cables are meant to be separated before the end user receives them and I just got unlucky.
jesse
Reviewed in the United States on October 19, 2020
Very good quality, its plug and play no need to solder or cut wires to get your printer back up and runing.
DrFrog
Reviewed in the United States on July 4, 2019
These were extended and worked great.
Karen
Reviewed in the United States on January 12, 2019
Used on an off-brand Prusia i3 - but the connectors fit the desired way. Had to rewire, but that's easy with the JST connectors, just use a tiny screwdriver or knife blade to gently pry the tongue back to release the pins.
Pat's Prints
Reviewed in the United States on April 3, 2019
They were wired backwards for the motors I used them on. Could have been the motors not the cable because they were some off brand motors. flipped the cables quick and they worked good
MakeCents
Reviewed in the United States on July 9, 2018
Shipped in timely manner. Pay attention to the images and the wire positions. This configuration was not right for my needs. I had to swap three of the wires on each. There are tiny tabs on the side where you can see metal. Gently pry those slightly up while gently pulling out the wire to release. Then simply push back in the right places. Anet A8 3d printer stepper motor wires.
PK9394
Reviewed in the United States on December 20, 2017
I have heat issue due to the mainboard is right below the heated bed. which I think is a bad design of the Kossel printer. Some people just mount the board outside the frame. Instead I mount the board to the top. all 4 motor cables will need to replace to a longer one. and this set of 4 just do the job.
Recommended Products
$12.50
$ 6 .99 $6.99
$17.89
$ 8 .99 $8.99