Your cart is empty.
Your cart is empty.Product Description
Connecticut Electric manufactures new high quality replacement circuit breakers for Stab-Lok load centers that accept NA style circuit breakers. Circuit breakers should only be replaced with new tested and Safety Agency Listed circuit breakers, never used or refurbished ones.
From the Manufacturer
This 120/240 volt Federal Pacific Electric, 60 amp, double pole, thick series replacement circuit breaker is used in a Federal Pacific (FPE) load center and/or used for feeding Sub-Feed Panel Boxes. This is only a suggestion and cannot assure your compliance with all local codes. Please check local electrical codes before starting any electrical project.
Donald Wolcott
Reviewed in the United States on February 10, 2025
Replaced previous breaker with no issue.
K. Gunton
Reviewed in the United States on January 24, 2025
Shipped without the lugs so it's completely useless.
Kevin
Reviewed in the United States on September 30, 2024
working great a few years later
WILL
Reviewed in the United States on August 1, 2024
So far it works as it should. It is a little bigger in width so i had to move so other brakers around to make fit.
Mohammad S.
Reviewed in the United States on June 6, 2024
Good
Gary
Reviewed in the United States on June 12, 2024
This breaker fit perfectly in a stab lock distribution panelWork great
Bob M.
Reviewed in Canada on May 24, 2024
This breaker works well. It eliminated a ground fault I had on my hottub circuit.
Jeff
Reviewed in the United States on January 31, 2024
Bought this to replace an old breaker for my heat pump that kept tripping. It fit right in and works fine, I do think the reason the old breaker kept tripping was because the lugs that hold the wire needed to be tightened. I did this before replacing breaker and it solved the problem. I'll keep it as a spare.
Werner
Reviewed in Canada on March 18, 2023
This was better priced than local Depots and worked well.
Frank Provasek
Reviewed in the United States on December 3, 2023
Replaced a 40 year old breaker that started nuisance tripping when backup electric heat came on in a heat pump system. Problem fixed. Don't get conned that FPC panels have been recalled, are going to explode, can't buy insurance. Not true. Home Inspectors flag these based on the brand, and assume other panels are OK if they are some other brand, which is lazy and dangerous. As you can see MINE from 1983 with the inside panel off, there are no burned or melted wires, no warping or discoloration from overheating, the breakers are tight, they flip on and off without binding. All boxes should be checked and replaced if their condition warrants. If you are buying breakers I assume you know how to safely install them.
cgala
Reviewed in Canada on December 3, 2023
This did the trick and was convenient to order through Amazon rather than search in a parts place. Came fast and on time and worked perfectly.
Jenn ILG
Reviewed in Canada on August 24, 2021
It fits perfectly in my Federal Pioneer electrical panel. My panel accepts either NC or NA breakers. So you know,this breaker takes up 4 spots in the panel which works for me since I installed a generator panel which freed up space but might not work for everyone. I highly recommend this breaker as a replacement for a NA260 breaker since they are very hard to find right now.
USER20
Reviewed in Canada on October 2, 2021
Ordered hoping it would fit into a cdn federal stablok panel as they are hard to get.It does fit but takes 4 spots in the panel. Arrived in so so shape bottom scratched badly but not as bad as some of the pics posted.
Recommended Products
$26.70
$ 12 .99 $12.99