Your cart is empty.
Your cart is empty.Product Description
FUNCTION:
Amerbm 2 jaw Bearing Puller Widely use in various bearings that are not easy to disassemble. Can also be used for automotive flywheel, motorcycle wheel, scooter motorcycle bearing and gear and so on.
Feature of product:
Applicable:
Applicable bearing dimension: 30-90mm Diameter
Material:
Made of #45 carbon steel, heavy-duty structure use oxidation treatment for corrosion resistance.
G88 Screw:
The screws are made of medium carbon steel and are heat treated (quenched, tempered).
Nominal tensile strength 800N/MM2 Nominal yield strength 640N/MM2.
bluemoon5658
Reviewed in the United States on February 25, 2025
Exactly what we needed.
George Forster
Reviewed in the United States on May 9, 2024
had to pull a bearing race off a pinion gear sort of wish the jaws were a bit shorter but all i had to due was put a 1in spacer and things were good to go
Rich
Reviewed in the United States on October 29, 2024
Does not work on its own to pull tight gears. Product would work better it it had hooks on the claws to hook the gear from underneath. The claws kept slipping off
Blitz-Dobe
Reviewed in the United States on August 2, 2023
If you need to remove the timing chain gear from an LS engine it will do the job. Note: I did have to use a large channel lock pliers to hold jaws in place to get started. Other wise they would slip off the gear while pulling it off.
William Wood
Reviewed in the United States on July 27, 2023
Great puller it does a great job it got to a bearing that was in a forever spot, myself and this puller got it out. Hooray. Next problem please!
Mike
Reviewed in the United States on February 25, 2023
Low quality steel tool. This gear/bearing puller is thin and small enough for small jobs but the jaws snap easily. Broke two of theses trying to pull a T355 input shaft bearing out. The jaw feet are too thin to hold up to any medium/heavy use.
Customer
Reviewed in the United States on April 9, 2023
The tool is exactly what you see but the arms are pretty flimsy and the jaws are not quite deep enough to actually hold anything. I had to rig a hose clamp on the outside to hold the jaws in from constantly spreading apart and slipping off.
PNW
Reviewed in the United States on April 14, 2022
The concept behind this product is great but the design needs some help. The range of bearing sizes this thing accommodates is awesome. However I was unable to get it to work as is. The arms will slip off the bearing, no matter how they are adjusted, as there is just too much flex in the system and the little lips that grab the edge of the bearing are too small. However what I did was put a trigger clamp across the arms once it was on the bearing to hold them in place, once I did that it worked great.
Recommended Products
$24.45
$ 10 .99 $10.99