Your cart is empty.
Your cart is empty.Product Description
Perfectly fit for all Yamaha Suzuki Johnson Evinrude Hydraulic Trim/Tilt End caps, also suitable for All Seastar Hydraulic Steering End Caps.
Designed to rebuild the leaked device on outboard engine, hydraulic trim and tilt unit used to remove/ install the Trim & Tilt Caps without damage it and the steering cylinder
There are three different sizes (32mm, 35mm and 38mm). This pin wrench tool set will make it a breeze in removing trim/tilt that just make sure you choose a correct size wrench when use.
Our MT0004+MT0006+MT0009 wrench set allows you to open the cylinder in minutes without any grief and put it back together with confidence.
Operate easily, only makes both pins line up with the hole and insert, then work with 1/2" breaker bar (Not include).
William C Miller
Reviewed in the United States on February 10, 2025
Used the Yamaha size to remove the top trim cap .Worked excellent. Had some torque on it and no breakage of the pins .Worth a try for 25.00 $ .
Boatman7lakes
Reviewed in the United States on July 29, 2024
No issues
André
Reviewed in the United States on June 2, 2024
The tools are the right size and the pins are very strong. It did the job well.
Chris Fischer
Reviewed in the United States on December 24, 2024
it worked well for my trim cylinder caps (Yamaha 250 SHO) , at a fraction of the higher priced tools. I replaced the seals and they are nice and dry.....no more sheen in the water. Plus it has the tools for the TILT cap and the steering tube caps!!!!! I made my own part in the past and it was a real struggle. This works PERFECT! You will need it eventually if you're a DIY boat fixer like me. Or else you can spend thousands at the local shop if not.
Customer
Reviewed in the United States on December 17, 2024
This tool set is well made and did the job well. I had to remove the caps on my Yamaha outboard power trim cylinders. I highly recommend the tool.
Vickimarie
Reviewed in the United States on October 11, 2024
Bought this to repair the lift cylinder on our 2012 evinrude 90 hp outboard. These spanners do not fit the end cap or piston spanner holes. NOT a happy camper. See if you can find an adjustable one.
Cheech
Reviewed in the United States on July 22, 2023
It worked perfect it did what it was supposed to do nice quality for the money
Amirul Lasker
Reviewed in the United States on June 2, 2023
Cheaply made Chinese product. Didn't fit my sea star steering glands as advertised. The pins are off by a millimeter or so. Spend the money and get the good ones made by ONI tools which I got now and fits perfectly or the ones made by Marine tech. Save yourselves some headache!
Recommended Products