Your cart is empty.
Your cart is empty.The TP-Link PoE++ Injector (TL-PoE170S) expands your network to reach areas where there are no power lines or outlets and you wish to supply power to devices such as Access Points, IP Cameras, IP Phones, and more. This PoE+ Injector is fully complies with IEEE 802.3at/af/bt standards and can work with all IEEE 802.3af/at/bt PoE Compliant PDs (Powered Devices) or PoE Receiver Adapters, such as TP-Link's TL-PoE10R, or other equivalent products.
Nova03
Reviewed in the United States on July 15, 2024
I used this for work as a testing unit for some problem PoE devices, it did its job well and helped me do mine.
Prasanna Rupasinghe
Reviewed in the United States on June 22, 2024
Works as expected and described, used to power on some of the heavy access points by cambium XE5-8s, zero issues! *****
Tychee
Reviewed in the United States on June 19, 2024
It's exactly what it is. What more is there to say?
Paul
Reviewed in the United States on March 6, 2024
Nothing to extravagant, does what it says and powers the POE++ switch which then powers POE/+ cameras. A little larger than some other devices but not something to hold against it.
DeusEx
Reviewed in the United States on January 7, 2024
I have two Unifi Flex switches. These are quarky little entries in the Unifi lineup as they are are 5 port gigabit switches that do have 4 POE ports but no internal power. The power for the switch and for any downstream POE devices is supplied by an upstream switch or POE injector.They do support (and recommend) 802.3bt 60W as the the power supply. These TP-links work well for that use. I have two switches and two injectors. The first is powering an access point and a PTZ camera. The second is powering three stationary cameras. You may notice the POE availability listed as 46W. This is a self imposed limit inside of the switch as the remaining 14W is to ensure the switch isn't starved of power by overrunning the injector.The injectors are in a garage and have shown no issues in six months. They run cool and haven't shown issues about the lack of temperature control. I would buy again.
UnboxingProjectDotCom
Reviewed in the United States on September 19, 2023
Delivers power as expected but gets pretty hot to the touch.
Darbco
Reviewed in the United States on August 20, 2023
Nearby lightning strike blew a component clean off the motherboard! No fault of the unit but would have been nice if it had some kind of surge protection.
Customer
Reviewed in Canada on June 20, 2023
Does the job easily. Put out the kind of power you expect.
Mike Hiltz
Reviewed in Canada on June 1, 2023
Compatible with several SFP vendors and no loss in throughput.
Woody
Reviewed in Canada on May 23, 2023
These did not power up my Ruckus APs and I had to get the ones from Trendnet which worked without an issue.
Ghaith
Reviewed in Saudi Arabia on November 29, 2023
more than I expect, accurate description , I recommend
Jarrod D
Reviewed in the United States on December 6, 2022
I purchased these PoE injectors for some WiFi 6E access points. They worked exactly as they should. My APs only use 36 watts so I can’t say whether these can put out the full 60 watts, but they should.I will note that these are very large — roughly twice the size of other PoE injectors. That may make install location a bit tricky, but they’re great for the price.
Recommended Products
