Your cart is empty.
Your cart is empty.Ernest johnson
Reviewed in the United States on October 3, 2024
This is about 1/2inch too wide for the shaft on the knockout. This makes it impossible to screw anything to the shaft. Worked well with a 5/8th bolt. But I still would rather have one that works with the knockout.
Dave Downing
Reviewed in the United States on March 5, 2023
Works perfect Hole size right on the money. Thanks for the fast delivery.
Jenni
Reviewed in the United States on July 2, 2022
Used this for my classic Fiat Spider 124. When I order my center rocker panel it said it was made with original tooling, but none of the wholes were dimpled, so I bought this to remedy the situation. Was slightly small for my application, which is not the tools fault, so I just made sure to keep the body panel nice and level on the press and it worked great.
Kevin
Reviewed in the United States on May 17, 2022
I used this to flush mount a drain on the plasma table. Worked perfectly
Arno U.
Reviewed in Germany on May 11, 2022
Die Version „1/2" conduit size / 0.86" actual size“ hat folgende Abmessungen:Männlich: 11,2x21,3x28,9x37,0mmWeiblich: 11,3x21,8x29,8x36,9mmMit 0,5 Zoll hat das absolut GAR nix zu tun; die 0,86“ (21,844mm) „actual size“ passen immerhin ein bisschen zum Zapfen bzw. dem (ursprünglichen) Loch im Blech.Zum Pressen eignet sich eine Schraube M10x65. Besser noch UNF 7/16“-20 x 2 3/4“, da größerer Querschnitt und feineres Gewinde. Die Schraube muss (für 1,5 mm Stahlblech) nicht mal hochfest sein. Einfach mit einem langen Ratschenschlüssel anziehen (z.B. 60 Nm), fertig ist der Kragen. Mutter, Gewinde und Scheibe gut schmieren, damit sich die Schraube nicht mitdreht und es keinen Verschleiß gibt.Nach 20 Kragen noch keine nennenswerte Abnutzung, das Werkzeug wird geschätzt noch hunderte weitere Male halten. Sehr hartes Material.
samantha simons
Reviewed in the United States on September 22, 2021
Hole size is 1/8 linch arger for conduit keep that in mind. Work's great us it in a Knock out punch
bruce peters
Reviewed in Canada on September 20, 2021
Product arrived in good condition. However, it is the wrong size. The packaging says " 1.25", but the die is 1.75". I will keep it, as I can use it on other projects, but is useless for current project. I gave it one star, as it does work well.
Customer
Reviewed in Canada on August 21, 2021
Build well good tools
Tim Buchholtz
Reviewed in the United States on May 25, 2021
Worked flawlessly with a harbor freight hydraulic knock out punch.Highly recommended
Rick W. Stone
Reviewed in the United States on December 13, 2021
Good heavy piece and it worked very well.
Denis
Reviewed in the United States on August 24, 2020
Used this dimple die on my frame boxing plates. Plates were 3/16" thick. It did need about 25,000 psi to press
Recommended Products
