Your cart is empty.
Your cart is empty.These are continuous rotary encoder switch with a built in push button switch (push to operate).Can be used for data entry as with modern in car CD players, for volume or on/off control or data selection via LED or LCD display.Perfect for use with PIC or ATMEL microcontrollers.
I'm a real customer
Reviewed in the United States on January 13, 2025
..That the pins on these are very thin and delicate and NOT meant to be pushed into a breadboard!These are missing the circuit board and pins, they are the RAW component. Look a bit more at these and compare the others with the 5 pins on the circuit board.In my case I snipped the paper-thin tabs off and soldered thick wire that will work with a breadboard, etc.Good luck.
Brian
Reviewed in the United States on October 11, 2024
Exactly what I wanted
Ms. Moneypenny
Reviewed in the United States on February 21, 2023
This is a very high-quality encoder. Whereas other encoders like this have the rotary-encoder action only, this one features the push-button alternate-action so you can enable/disable the encoder action.
M Fry
Reviewed in the United States on December 13, 2023
Used as a replacement part for a cheap Chinese DDS frequency generator. Cheap fix and now I have four more for other repairs. Recommended.
Ben Wagner
Reviewed in the United States on May 5, 2022
While the final installation will be panel mounted with soldered connections, prototyping with these was a bit annoying as the pins seem very thin and they don't work well with jumper wires that I was using. Also, didn't work with a breadboard. Quick bit of solder and some wires and issue was fixed, but keep that in mind if you're prototyping in that fashion. Also, because of the metal used for the pins, I wouldn't bend them or move them around too much as I felt like they'd break off pretty easily. These worked for my purposes.
Vladimir K.
Reviewed in the United States on December 12, 2022
Do not work. Looks like internal contacts are misaligned. A bit better when rotating in one direction, and absolutely inconsistent in opposite derection. Tried 3 of 5 - same result. And yes, my project works just fine with other encoders (with shorter shafts), but I need long shafts for my front panel.
Recommended Products
