Your cart is empty.
Your cart is empty.Nate
Reviewed in the United States on February 3, 2025
I will start with this... if you need to control the flow of air to a low flow rate (like 1-2 CFM) this is not the device for you.I cranked down on it to try to get the air flow regulated but it simply will not go that low. It slowed air flow down a little but not much... I cannot recommend this product.
CableGuy
Reviewed in Germany on January 12, 2025
Ein sehr guter Regelventil das überall montiert werden kann und die Feineinstellung funktioniert sehr gut.
gianluca
Reviewed in Italy on August 8, 2024
È una azienda molto seria prodotto ottimo
Joe M. Dragavon
Reviewed in the United States on June 27, 2024
I was able to reduce the flow rate and avoid the 'sonic burst' even at 5psi CO2 pressure through the solenoid. Great to control low flow CO2!
Antonio Jesus Pavon Mauriz
Reviewed in Spain on May 25, 2024
Auque la válvula está diseñada para regular aire, yo la uso para regular el paso de taladrina y funciona perfectamente,
ZRO
Reviewed in the United States on March 7, 2024
Worked as described
JAY
Reviewed in the United States on January 11, 2024
Easy to install. Easy to use the air flow regulator.
the warm dude
Reviewed in the United States on January 11, 2024
I first tried the valves by connecting as the image in the description shows and I couldn't get the flow to shut off at pressures under 10 psi. Then I thought about it more and looked at the poorly shown diagram which shows the direction. Actual flow is mirrored from pics in the description. Swapping directions fixed that problem.For the cost, they work fine.
Rusty Minter
Reviewed in the United States on April 22, 2024
Perfect for my pneumatic project
Printier
Reviewed in the United Kingdom on November 27, 2023
A pretty standard pneumatic speed controller with check valve in the reverse direction.Comes with a locking nut to keep the setting.The cracking pressure of the check valve is approx 110mbar. (10mm tube version)
PF
Reviewed in the United Kingdom on November 21, 2023
Review of TAILONZ PNEUMATIC 10mm Air Flow Control Valve,These control valves are used to to control speed by restricting the air flow, no so much a pressure reduction but a quantity reduction, as advertised these are for pneumatic cylinders and control the speed the pneumatic cylinder arm exits the cylinder to move objects attached to it, such as opening and closing a door.The maximum working pressure stated for this valve is 1 MPA = 10Bar = 145Psi, the quantity of air supplied controlled by the top screw moved downwards to restrict air flow, this knurled for grip as is the locking ring on the thread, two screw holes at either side of the flow restrictor allow for permanent fixture.The 10mm air supply pipes are push fit into the connectors either side and are designed to grip tighter the more pressure applied also to allow 360 degree movement of the valve for positioning, the blue ring outer can be pulled towards the valve body to release the air supply pipe if required.In use these valves work as intended, appear of quality construction and easy to use, once adjusted the screw can be locked to maintain specified air flow. With the materials used for construction one can easily imagine they will offer a good lifespan in use.
ken m.
Reviewed in the United States on April 12, 2023
Working with pneumatic air line, this push to connect adjusters, work extremely well, and easy to fine tune. Would recommend.
Joseph
Reviewed in the United States on June 27, 2021
one of the valves was loose inside the plastic molded container where the pot is turned -- wish i realized it before i wired and mounted it up - but oh well - lost maybe 1/2" of line and this pack included many valves so i just replaced with another. the other 2 i am using work fine. no noticeable air leaks and i don't have the best crowns on the line either. very satisfied
Recommended Products