Your cart is empty.
Your cart is empty.Sure-Grip Zero Nutz are made of nylon to be a super lightweight alternative to traditional aluminum axle nuts. With a built in dust shield, will add style and protect your bearings!
Brandi Macon
Reviewed in the United States on September 26, 2024
I got these in a couple colors. They work great for wheels that the nuts don't lace all the way. The colors are cool too! Also great at keeping bearings clean!
Amitesh
Reviewed in the United States on June 12, 2024
I bought these Nut bearing covers for two reasons.First: to keep dirt away from the bearings and they have done a tremendous job so far. I mostly skate outside around lots of parks and beach. so far, not much debris/sand have invaded the bearings on my skates.Second: for the looks. I am going for black and neon green combo for my skates. and these nut bearing covers looks amazing for their price.Just note that they are hard plastic material, but they haven't given me any problem at all.
Acmeles22
Reviewed in the United States on February 17, 2024
This “colored axle nut,” although plastic, looks nice but is easily cross threaded if not placed on properly. Thread should be metal and not plastic.
saolee
Reviewed in the United States on December 20, 2024
You have to slowly screw it on the axle. Take your time and make sure you use a socket and rachet to install. Keep it dead on flat and straight and you’ll be fine. 2 out of the set went on lop sided.
Rsctt
Reviewed in the United States on December 15, 2024
Work well, they cover your bearings so no gunk will get in there. They’re plastic so make sure you’re careful when screwing them on. They’re fit well and you can screw it down enough so your wheels have no wobble at all.
master cheif and sky guy
Reviewed in the United States on November 25, 2024
Works perfect, I was worried it would not work with skateboards, since they are for skates. But they worked perfectly! It will definitely fit your wheels size too. I bought it to block water and debris out, it does its job perfectly and does not reduce speed. Also since they include 8 nuts, one package works for two boards.I highly recommend this product! You should buy.
Castro
Reviewed in the United States on October 2, 2024
Short version, I like them so much better than metal nuts. Great fit. Great hold.Longer version, I switch between my smaller indoor wheels and my big soft outdoor wheels. The outdoor wheels are wider and caused the metal nuts to keep falling off. These fit great and don't slip off on any of my wheels, even with all the giggling of outside skating.
Sienna Scott
Reviewed in the United States on May 9, 2020
They seem to be serving their purpose. These covers replace the traditional nut and washer that goes outside the bearing. Giving four stars because they're not as sturdy as thought they would be. The first one I cranked on too tight, and messed up the nut so I couldn’t screw it on and off as easily. It still works, just requires a bit of special attention with my skate tool to remove/tighten. The rest of them I was more gentle with tightening them. Take it from me—these plastic bearing covers are not meant to be cranked on as tightly as traditional nuts! But they will still keep your wheels on plenty tight enough and add a pop of color to your skates.
Recommended Products
