Your cart is empty.
Your cart is empty.
Our kiln-dried maple fingerboard has flat undersides, is unfretted (no inlays), and is ready for trimming to fit a variety of neck widths.
This slotted fingerboard for Fender Guitar features:
- 25.5" scale
- 12" radius
- 24 fret slots + nut slot
This fingerboard is radiused and extended to include a 1/8" flat-bottomed nut slot, Fender style.
Tip: Saw the fingerboard shorter at the 2nd fret (at the nut end) to install it on a Gibson 22-3/4" short scale guitar.
Fingerboard specs:
- Approximate dimensions: 2-3/8" x 20-3/8" x 15/64" (60.32mm x 517.53mm x 5.95mm)
- Radius: 12" (304.80mm)
- Fret slots: 24 slots, 0.023" wide (0.58mm)
- Nut slot: 1/8" wide (3.18mm)
Nathen and Sarah
Reviewed in the United States on January 24, 2022
My neck goes from 1 and 5/8ths to 2 1/4. I had to cut the neck and the wood was splintering. Bad quality wood. The fret slots were very shallow and not deep enough for the frets. A lot of work and I had to take it off anyway.
Customer
Reviewed in the United States on March 25, 2020
Low quality wood. Only roughly radius’d so you essentially need a radius sanding block to finish them.
Recommended Products
$5.99
$ 2 .99 $2.99