Your cart is empty.
Your cart is empty. This hybrid bipolar Nema 14 stepper motor with 1.8 deg. step angle (200 steps/revolution).
Each phase draws 800 mA at 5.4 V, allowing for a holding torque of 18Ncm(25.5oz.in).
Electrical Specification:
* Manufacturer Part Number: 14HS13-0804S
* Motor Type: Bipolar Stepper
* Step Angle: 1.8 deg.
* Holding Torque: 18Ncm(25.5oz.in)
* Rated Current/phase: 0.8A
* Phase Resistance: 6.8ohms
* Inductance: 10mH+/-20%(1KHz)
Physical Specification:
* Frame Size: 35 x 35mm
* Body Length: 34mm
* Shaft Diameter: 5mm
* Shaft Length: 24mm
* D-cut Length: 16.5mm
* Number of Leads: 4
* Lead Length: 400mm
* Weight: 190g
Connection:
Black(A+), Green(A-), Red(B+), Blue(B-)
Warning:
Make sure the motor connect to a constant current or chopper drive controller before you test motor.
Connecting the motor directly to a power supply will destroy the motor.
Jesse
Reviewed in the United States on July 31, 2023
I use a lot of steppers and I've had great luck with those from StepperOnline. I typically use larger NEMA 17 or 23 units, but these little 14 models are very useful for smaller projects. I used them for rotators and focusers on small telescopes and guidescopes. The dimensions are accurate and the mounting threads are clean.
Byron N.
Reviewed in the United States on March 12, 2022
Ordered for accessory for my steam engine.
zobotek
Reviewed in the United States on August 1, 2020
No problems with this stepper. It's fairly quiet, smooth and does what it's supposed to do.
DLC
Reviewed in the United States on March 1, 2019
These are quiet. I hate the fixed wiring - but you can’t get NEMA14 steppers with six-pin connectors anymore. What’s with that?
AjG
Reviewed in the United States on September 3, 2018
X axis was skipping. It seems the bearings in the X axis stepper had failed.This unit was a direct replacement except for the fact that you may need to attach the original servo plug to the end of the cable. Running Solidoodle 4 with ATMega + RAMPS1.4.
dave818
Reviewed in the United States on April 15, 2018
These are great little motors and ultra-quiet. BUT it's REALLY important to look closely at the documentation on this page. They are rated for 5.4V not the typical 12V you normally see for steppers. If you hook these up to a 12v supply they will stutter and stagger and you will be sad. Hook them up to 5v and they are quiet and smooth.Also mine came with a nice little sheet with all of the relevant information, so not sure why some are saying no docs.
Mike Peterson
Reviewed in the United States on March 8, 2017
Works fine
Ted O.
Reviewed in the United States on December 6, 2016
No documentation. I've looked on line and can't find much. It does appear to work. I'm using it with an Arduino.
Recommended Products
$37.03
$ 17 .99 $17.99