Your cart is empty.
Your cart is empty.Product Description
-
Step 1
Install the Starlink Gen 3 Mounting Kit on the wall by 3 screws.
-
Step 2
Slide the power supply into the lower slot.
-
Step 3
Wrap the wire then fix it with zip tie.
-
Step 4
Plug the network cable into the Starlink Gen 3 router.
-
Step 5
Slide the Starlink Gen 3 router into the higher slot.
Jason Cook
Reviewed in the United States on February 14, 2025
Holds the power supply and router and gives it a cleaner look.
Mr. & Mrs. Wood
Reviewed in the United States on January 4, 2025
The media could not be loaded.
Alicia Scott
Reviewed in the United States on January 29, 2025
Very clean set up. Easy install.
Ashley P
Reviewed in the United States on January 29, 2025
The media could not be loaded.
Patty Melton
Reviewed in the United States on January 25, 2025
The media could not be loaded.
F. Davies
Reviewed in the United States on January 23, 2025
The Starlink mount is just what we needed to get the starlink router and power to the top of the roof area for best coverage. It is simple to install with three screws and then simply slide in the router and the power supply and it is secure.On another note, the support has been wonderful. We are at a new address and the first two attempts to get the starlink mount delivered were frustrated by a non-responsive carrier. To correct this the support team tried made multiple phone calls and listened to us when we told them which carrier would find us and shipped yet a third time. Wonderful support by the team. Thank you.
Martha
Reviewed in the United States on January 20, 2025
If you have a short distance between your satellite and router there is not enough room on back of the mount to wind and hide the cable as the mount fits fairly flush to the wall. We were fortunate to have easy access to our attic so we drilled a hole and pulled th excess cable through to hide it.
Daisy zhong
Reviewed in the United States on December 30, 2024
The media could not be loaded.
Recommended Products
$123.84
$ 59 .99 $59.99