Your cart is empty.
Your cart is empty.Standard is the leader in the automotive aftermarket. Backed by more than 100 years of experience, we design, engineer, manufacture and distribute over 50,000 of the highest quality engine management products in some of the most advanced-technology categories. Our ignition and fuel-system components, sensors, switches, computerized engine controls, and all of our other advanced engine systems parts all have one thing in common –we won’t let them leave our facilities until they meet our strict quality standards. That’s how we know that they’ll meet your high standards.
JT
Reviewed in the United States on February 2, 2024
Just like some of the other reviews. The size is larger and the plastic snapped during the install
Malcolm
Reviewed in the United States on July 6, 2023
Nut size on this was 15mm while on old sensor was 13mm. Nut size is too large to get a socket on due to proximity to valve cover. Sensor broke during install. Do no recommend!
Austin Worthington
Reviewed in the United States on June 10, 2023
Installed, it worked, just looked at it today a couple months later, plastic part snapped possibly from heat and was held together by wire inside. Don’t buy, go get a quality one
Robert Barber
Reviewed in the United States on November 22, 2023
Normally standard motor products are descent quality. I didn't realize this was the T series which are lower quality. When they say lower, they mean LOW quality. I put this in, went to plug in the harness, and wiggled it a bit to make sure it seated and the plastic housing snapped. I'm actually glad it did because this wouldn't have lasted long. The way they manufacture these is a design flaw. The plastic isn't solid it is hollow and VERY WEAK. Save your $$ and get a better one. These are JUNK
Davey
Reviewed in the United States on February 8, 2020
I can read temperature at the gauge now
Ivette A
Reviewed in the United States on August 3, 2016
Fit perfectly and now my temp gauge works perfectly!
Robert
Reviewed in the United States on October 26, 2016
Does not fit my 96 jeep cherokee had to go to auto zone and get the right one
S. Loglisci
Reviewed in the United States on September 1, 2014
Fit my cylinder head on my 1994 Jeep Cherokee..works as it should, pretty simple no moving parts.
Recommended Products
