Your cart is empty.
Your cart is empty.Standard Motor Products RY-640 Relay Assorted , One Size
Steven Powell
Reviewed in the United States on December 10, 2021
When purchase it guess it was problem it new not use it that was not problem
Ricardo catalan
Reviewed in the United States on January 17, 2020
Fit perfectly... and works perfect will recommend to buy again
Customer
Reviewed in the United States on January 13, 2019
I replaced my relay (just behind the fuse box) with this one. It worked fine but my blower motor still doesn't work correctly. I just noticed that is does work a bit when I have the air setting configured to flow into the car and not recycle.
Jordan R.
Reviewed in the United States on October 25, 2018
I have a 07 Nissan Altima and have been issues with the heat taking forever to come on. There have been times where it never came on and I had to hit the dashboard under the drive side to get it to come on. This relay has worked and my heater is working at full power the second I start my car.
Lisa Walther
Reviewed in the United States on January 7, 2018
This product does not fit my car and it said it did. What do I do about this ?
Eshwar S.
Reviewed in the United States on February 14, 2017
Great product
RetCountryLivin
Reviewed in the United States on July 28, 2015
Fixed a blower issue I was having on my 04 Murano. Funny, after reading through the entire troubleshooting section of the factory manual not once did it mention this relay. If you have access to the manual the relevant pages to correct the blower shutting off on you are: IP-10, 11, 12 PG-69 and EI-32. Fast shipping, and plug and play. Took me all of 15 minutes.
Gift Card Recipient
Reviewed in the United States on November 20, 2013
I purchased this relay for my 2007 Nissan Altima. My fan wasn't working on my heat or air so I did some research and found out it was this relay.A helpful hint to whoever is changing one out; It is mounted behind the fuse box and to the far left. Remove the fuse cover and you will see a large screw that holds the knee panel on. Remove this screw and the panel will drop down some. Then to remove the fuse panel there are three hex head screws (I believe they're 8 millimeter) one on top and two on the bottom. Remove these to have access to the blue relay in the far left. After you have access to it, it is a little difficult to remove because there is limited space. I used a Visegrip needle nose plier to clip onto it and pulled straight up. It worked like a charm. Remember to look at the relay when you remove it so you can replace it the same way as you removed it. I think the two brass colored prongs go towards the back but check to be sure.Start your car and turn on the fan to make sure the relay is seated well.I'm pretty sure I saved a couple of hundred bucks by doing it myself. Good luck and be patient while doing this.
Recommended Products
