Your cart is empty.
Your cart is empty.Established in 1919 and traded on the NYSE, Standard Motor Products, Inc., (SMP) is a leading independent manufacturer, distributor, and marketer of replacement parts for motor vehicles in the automotive aftermarket industry, with a complementary focus on heavy duty, industrial equipment and original equipment markets.
john waller
Reviewed in the United States on March 4, 2024
good
José Luis crespo López
Reviewed in the United States on December 22, 2024
Muy buenos
Joe S.
Reviewed in the United States on October 14, 2024
Great
marion tharrington
Reviewed in the United States on April 24, 2024
Standard Motor Products NS85T Neutral/Backup/Safety Switch was the best priced and quality at the time I ordered this switch. I would recommend if you have to replace yours.
Customer
Reviewed in the United States on September 14, 2023
This neutral safety switch worked great on the s10 1997 4x4 !!!!!!
Russel swan
Reviewed in the United States on November 11, 2023
The media could not be loaded.
L. Stevens
Reviewed in the United States on June 27, 2020
With the shifter in neutral it installed with no problem. After looking at a bunch of install videos I will comment on the real world vs on line how to. Heating the electrical connectors with a hair dryer( for removal) did help,but the real trick (my own,no pwr tool needed) is sand the bolt shaft (a lot) with a band of sand paper& spray DW40. That allows the old part to gently pry off the shaft,& this new part will push on without hang ups. Installed linkage, & no adjustments needed. All tail light functions vs shifter positions work. After test driving & rechecking I can say it shifts fine. This was installed because of intermittent starts when turning the key. Now the key cranks the already replaced starter every time.
Stephen Barber
Reviewed in the United States on May 8, 2020
Back up lights were not working. Check everything but determined it was this switch. Lights had not been working since having transmission replaces. when I removed old switch I compared old with new and noticed one of the pins on the old switch were missing. That was the problem. Just a word of advice . follow the directions provided. and be prepared for a hard time removing the electrical connectors from the old switch as GM used some kind of adhesive to hold them in. Not impossible but go slow when trying to remove them. Installation of this switch was easy.
Recommended Products
$44.33
$ 21 .99 $21.99