Your cart is empty.
Your cart is empty.Stainless Bros SS304 90° elbow has a 16GA/.065" wall thickness to work perfectly with our straight tubing. Extruded from our 16GA/.065" 304 Stainless Steel, you wont find a higher quality bend on the market. Each elbow is individually extruded, the ends are laser cut and then they are ultrasonically cleaned to provide a ready to weld solution right out of the package. Stainless Bros eliminates the difficulty and potential material waste from bending your own tubing by utilizing our own proprietary cnc extrusion process to provide a perfect bend every time that is wrinkle free. Our Stainless Steel elbows will drastically reduce the fabrication time needed for producing a full Stainless exhaust system when pie cuts become too time consuming.
Damien Mikkelsen
Reviewed in the United States on July 4, 2024
If you’ve ever cut a Ubend on the radius you know the struggle of spring back deforming the tube. These are great no spring back I was shocked. Clean inside and what looks like maroon scotch bright finish inside and out. Also no tooling marks
Jeremy Thacker
Reviewed in the United States on June 9, 2024
It is the right size
Customer
Reviewed in the United States on October 23, 2023
Great mandrel bends and nice polish. Welded up perfect!
george ritter
Reviewed in the United States on October 2, 2022
Great
timothy
Reviewed in the United States on April 8, 2021
These 5” 45 degree elbows are super high quality. Unfortunately I ordered the tight radius 5” 90 degree elbows so these won’t work and I’ll be shipping them back to hopefully get the correct parts
LY
Reviewed in the United States on September 23, 2020
This 1.5 Stainless elbow is better then expected. It is smooth and does Not have any burrs on it at all. It is sturdy and thick. I used it to make a sharp turn for gas fill.
CalBob
Reviewed in the United States on December 13, 2018
I used this for some exhaust bends to to get out to the back of my project car; but you would be proud to have it in your engine compartment as part of a turbo installation. Photo shows the up and down curve over the leading edge of the lower rear suspension A arm where I used the right angle bend cut into two pieces and welded back together.
Gustav
Reviewed in the United States on November 17, 2018
I bought this one and the 45deg bend. This is a super tight super clean bend. No Mark's on it at all. Its 304ss and welds really nice. Descent wall for a turbo application or where it need to hold ui p something like the wastegate or turbo. The one on the right in the pic
Recommended Products
