Your cart is empty.
Your cart is empty.Product Description
Premium Heat Shroud
Heat shroud sleeve aluminized sleeving is made of high-temperature resistant fiber glass fabric with an aluminized outer surface.
Wide Applications
Widely used in protecting spark plug wires, fuel line heat shield, starter heat shield, wiring, brake lines, intake tubes, pipes, battery cables, A/C hoses etc which need insulation
Double Stitched The Seams
We double stitched the seams and even finished the edges of the seams, so it won't look ugly and worn in your engine compartment.
Usages
Easy to Install
Xavier T. Le
Reviewed in the United States on January 12, 2025
Cut this to spec and used inside engine bay
Joe Consumer
Reviewed in the United States on June 7, 2024
Used this to wrap some wiring on my Hummer H3 that is so close to the exhaust system that conventional split loom melts/deforms. This product works like a charm to keep my wiring cool. Easy to cut to length, install and secure. The length of the insulation I received was the 71" shown in the product title and not the shorter length shown in the description.
vincent
Reviewed in the United States on October 7, 2022
Cable now protected from headers!
Loonasea
Reviewed in the United States on August 11, 2021
Extremely hard to work with unless what you're covering is perfectly straight. The stitching is pitiful, be very careful if you have to reposition the velcro because the stitching will immediately start to pull out .I ended up having to use an adhesive metal tape (like is used on HVAC systems) to hold it together. I was covering the heat bypass tube that goes to the EGR on my '90 Ranger, it has a couple curves in it and was VERY hard to cover.
Benjamin Smith
Reviewed in the United States on April 17, 2020
Works as advertised.
Brody
Reviewed in the United States on March 14, 2019
product works fine. used to cover oil feed lines for turbo that runs right through exhaust header. lots of fiberglass floating around after installing it wear gloves and breathing mask.
Dennis
Reviewed in the United States on December 14, 2019
This shielding works but cannot take direct exhaust contact. A portion touched against my exhaust and the shiny metal baked off of the fiberglass. The fiberglass then charred. Good product, but will not stand direct heat.Product update. Please see the attached photos of this shielding near exhaust. Notice how the foil has completely burned off. The fiberglass does hold up. When you install be sure to not let this come in direct contact with you exhaust.
Car Guy
Reviewed in the United States on October 21, 2019
Worked better than anything else I have tried on my 1966 Chevelle fuel line. It has greatly helped with eliminating vapor lock and is far easier to install than sleeve type of insulation.
Recommended Products