Your cart is empty.
Your cart is empty.These molds have wood handles and won't get hot after a long period of use. Type: remove spilt 1/32,1/16,3/32,1/8 oz. Insert: none. Cavity: 20 (5 ea).
2lazy2shop
Reviewed in the United States on April 20, 2025
All do it molds are great and this was no exception.
Jessie Buckmaster
Reviewed in the United States on January 5, 2020
Great mold!
Linda Palmer
Reviewed in the United States on March 21, 2019
The mold was delivered when promised and, as with all Do-it moulds, is a beautifully made bit of kit. Well worth the price. Thank you.
Catmash
Reviewed in the United States on April 11, 2019
Works great made thousands of lead weights
Michael Rivera
Reviewed in the United States on March 16, 2018
Preheat a must....built tuff....make you own handles for them as to pass 3 to 5 lbs and get handfulls of yur very own splitshot....
LeVerne Doran
Reviewed in the United States on October 19, 2014
You MUST keep the mold hot to have good castings. The handles should be longer. I often get burned when I have the mold open to remove the castings. The sprue is very large for such a small weight.
Tom Uzi
Reviewed in the United States on October 5, 2013
I would not recommend this mold unless you have a separate heat source for the mold and lead. The mold has to be very hot before the hot lead goes in. Good luck trying to get a full mold. There is a lot of excess that needs to be cut off. Get the purest lead for this split shot. I recommend replacing the wood handles with longer wood handles because the mold will be very hot and I always seem to burn my thumb because there is not much grip on the stock handles. Practice, practice, practice and you will get it to work.
Juan Valdez
Reviewed in the United States on January 7, 2012
This is a nice mold and as any other Do-It mold it works great! It works best to warm it up first then cast away. This mold makes a ton of small slip sinkers fast.
Recommended Products
