Your cart is empty.
Your cart is empty.Product Description
Paul C.
Reviewed in the United States on August 14, 2024
Not really that effective. Its use is overrated!
CJH
Reviewed in the United States on July 10, 2024
A simple blaster, fantastic for baking soda blasting. Will certainly try it with glass beads.Easy to refill the reservoir, large cap that threads on precisely. If your air is wet, it will clog, but the reservoir swings out allowing cleaning of the orifice. Simple.Made in the USA, that’s important to me.
Customer
Reviewed in the United States on May 12, 2024
Obviously you have to have a pretty big air compressor to run it. My compressor is 85 gal and set to about 110 psi. And I turned the flow valve slowly on the gun , with little Bursts of the trigger until it was set properly and it worked a lot better than I thought. And it saved me a lot of time. Prepping all the little brackets I needed to do.
chase bolton
Reviewed in the United States on December 17, 2024
Looks sturdy and very nice
Customer
Reviewed in the United States on January 30, 2024
Works very well. Very happy with it.
Jason Ross
Reviewed in the United States on September 11, 2023
I had a few smallish rust spots that needed to get cleaned out. Paired this with some sand and went to town. Worked great, was able to get the rust off, then fill/prime/paint. Rust stayed away for a decent while, then I had to use it again.The parts of the car that were getting the rust were the parts where chips and dings were pretty common. I've also used this for other jobs around the house where you need to sand something down but there's not a fantastic way to get an angle with a block sander, but I can get the nozzle where I want it.
Robert Nienke
Reviewed in the United States on February 8, 2022
Making sure to use a grit of media fine enough to pass through the gun. I used 40-80 grit glass bead I picked up at Northern Tool and it worked well. Use head and eye protection along with a quality mask, I'd advise a hood as well as you're going to be wearing the media in short order. It will go everywhere unless you have a containment around the blast area.This isn't meant for blasting a whole car, though if you are a glutton for punishment, it would most likely do it. Just be mindful the tips will wear in time and need replaced. Replacements are available at low cost. And you'll go through a bunch of blast media. I had no problem in my 1 to 2 hour blast session. Maybe went through 25 lbs of glass bead that I captured and recycled into my cabinet. Biggest time eater was refilling the hopper.
Kindle Customer
Reviewed in the United States on December 1, 2016
Our guys love this. We grabbed it to do some light cleaning of brick where flashing had previously been tarred in to place and it did the trick. It's currently making the rounds from job to job and I think our guys are making up excuses just to use it. It's not a super high end product, but for the price, it does the job without hauling out the big hopper for more serious sand blasting. Great for small areas that need some touch up. Should last for a while, but I don't see it lasting 30 years either.
Recommended Products