Your cart is empty.
Your cart is empty.Speed By Spectre, The 400mph company. Rooted in racing, we design and build every product with the same goal in mind; the best performance in the market... proven on the racetrack! Speed By Spectre couplers, tubes and related components allow you to design your very own custom cold air intake system. All of our air intake components are designed and built using high quality materials and engineered for optimum fit and function.
Roger J. Kneeland
Reviewed in the United States on February 7, 2025
Fit perfectly on a 2005 Jeep Cherokee 5.7 . OEM part would be about $75
Steve
Reviewed in the United States on July 14, 2024
Nice product
Noreastfish
Reviewed in the United States on March 21, 2021
Works good for my purpose
Marcus
Reviewed in the United States on August 3, 2020
Make sure you pay attention to the material of this, it’s not intended for high temp locations. Otherwise, works great and comes with clamps.
Mike Oxichi
Reviewed in the United States on August 29, 2020
Used this to attach the mass air flow sensor portion of the air cleaner in my 2002 Infiniti Q45. Once the engine warms up the material becomes extremely soft and whatever is attached to this coupler literally falls apart/off. Under normal driving conditions the MAF sensor detached from this weak coupler, forcing my car to stall at 70MPH and then again at 25MPH, making the vehicle inoperable and unsafe to drive. I sure do NOT recommend this coupler, not if you value your life or your safety.
Tiah Vagnoni
Reviewed in the United States on March 14, 2017
Part holds a lot tighter than I expected. You will need to grease it slightly for it to fit in. Giggity
Vaughn
Reviewed in the United States on April 13, 2016
Strong clamps and great quality rubber. It even has a built In stopper inside so the pipe can't go all the way through by mistake. Makes for ease to just tighten clamps. This was a good buy and I look forward to purchase from them again.
wilesre
Reviewed in the United States on August 7, 2014
Made of EDPM. So probably only rated to 200 or 300 degrees. Works fine in my engine compartment about 8 inches above the exhaust manifold. Silicone couplers are rated for 500 degrees. I have also purchased silicone couplers and found that they are about as flexible and easy to use as EDPM. Also these included hose clamps - the silicone ones did not. Given the choice I would pick these over silicone unless high heat was an issue.
Recommended Products
$64.85
$ 25 .99 $25.99
$161.95
$ 73 .99 $73.99
$359.78
$ 99 .00 $99.00