Your cart is empty.
Your cart is empty.FDP
Reviewed in the United States on March 23, 2024
I tested them at the lower end of the voltage spec, but they worked well. These are responsive, and could detect even small targets.
Chris
Reviewed in the United States on February 29, 2024
Easily mounted in place. The fact they are potted means they will last longer than the original sensors.Easily detects ferrous metals from around 4 - 5mm distance. The triggering spot is a little off from unit to unit, however, it's well within acceptable range.Please note. if you're using a 12v system, you should check to make sure the system will properly trigger, as the holds around 0.6 - 0.7vdc when triggered (NPN NO sensor)One of the control circuits i had decided that was high enough not to count as a trigger, so i had to add a pulldown resistor.
Marty
Reviewed in the United States on November 21, 2024
Work very well as home sensors on a CNC router
Recommended Products
