Your cart is empty.
Your cart is empty.Convenient screwdriver set for many small electronics repairs
Evan
Reviewed in the United States on September 23, 2024
Very pricey for what it is
Christian
Reviewed in the United States on May 12, 2024
This tool makes it easier to open an Xbox 360, saved me time from trying to pry each pin one by one.
Kevin S.
Reviewed in the United States on January 25, 2023
opened the case with no problem.
Patrick D. England
Reviewed in the United States on August 21, 2022
I run a small game console repair gig and didn't have a way to open an old Xbox 360 model for repairs. I grabbed this and it seems to operate as it was intended. My only complaint is to Microsoft for making the plastic portions of the case as the tool tend to break the old plastic if your FORCEFUL with it; not the manufacture's of the tools fault, just more complaint on the console developer's.
André B.
Reviewed in the United States on July 27, 2020
It's a flimsy piece if metal, punched out to fit the Xbox case snaps. It works but mine bent using extremely gentle pressure. It seems to be made for a single use rather than a tool you can add to your kit. If you can find a sturdier or professional version of this tool, it'll be worth any extra cost.
Customer
Reviewed in the United States on July 12, 2020
This opening tool for the Xbox 360 is very easy to use. The opening tool enables me to get them apart in a couple minutes without risk of damage.If you aren’t careful then you can bend the opening tool, but I’ve been inside a dozen or more units and the tool is still good as new. The Torx driver is inexpensive but has held up well and I have no complaints.Note that these tools will enable you to dismantle the original fat / phat Xbox 360 and give you access to the disc drive, cooling fans, fan shroud, and top of the motherboard. It does NOT include a Torx driver to remove the ring of light or the heatsink screws on the bottom of the chassis, so plan to get a set of Torx bits if you need to fully remove the motherboard from the unit.
Benjamin Heinisch
Reviewed in the United States on July 1, 2019
My main focus on this was the latch tool, not the screw driver, so I guess I'll get the driver out of the way first. It is very cheap, the mold isn't great, the swivel on the end is plastic on plastic and doesn't feel great, it can be hard to get a lot of leverage on it, but for the price, what do you expect? I had other drivers to use. As for the actual opening tool, it is a little bit flimsy and compared to another one I have that I got for a few cents more, this one seems a bit worse. It did get the job done, but I had to bend one or two of the prongs back into position once or twice. It should be noted that one of these isn't always required to open your 360, but it can be helpful. I personally can't get a phat 360 open without it, but I have opened several slims with a long metal pry bar (could use a screwdriver) and a thin metal jimmy tool without much issue.Long story short, if you just want to open your old phat to clean it and help prevent red ring, or to clean/grease your disc drive, this will work. If you want to use it many times over however, I would not expect it to hold up as well.
Salmagundi
Reviewed in the United States on February 21, 2014
This tool is cheap. If you need to open your xbox once or twice to replace a dvd drive or something I would recommend this to you. The tool is not so sturdy and bends easy but works like a charm. The screwdriver is great and works well. Overall i was thrilled.
Recommended Products
