Your cart is empty.
Your cart is empty. Specification:
Material: Carbon Steel
Length: 300mm / 12"
Drill Bit Dia.: 19mm
Hex Shank: 11mm
Warm Tips:
1.Please confirm the product size you need before purchasing.
2.Since we measure the product by hand, please allow 1-2mm difference between actual and manual measurement.
3.Our pictures are as close to the real item as possible, but there is a little difference in color between the two due to equipment, light and monitor.
Excelente
Reviewed in the United States on January 28, 2025
Excelente
Dave
Reviewed in the United States on January 2, 2025
Did what I needed it to do went right through wood
Isaac Schmaedeke
Reviewed in the United States on January 1, 2025
They came bent of course. About an inch of drift per 6 inches because of the bend. I figured maybe I bent it when I used it but nope, the unused one is just as bad. Also they're not 1/4 they're only .200 in diameter. Worthless.
Dave S
Reviewed in the United States on July 2, 2024
Used this to drill holes into a Spruce tree stump. In minutes I had a dozen holes bored 5 inches deep. The bit chewed through even the heart wood of the stump with ease and threw out the wood as it went to prevent any binding. My 18v battery drill struggled at the end - but not the bit.
SK
Reviewed in the United States on December 14, 2024
Used this to drill holes in a stump to dump chemicals in to rot it. It doesn't fit a standard drill/needs a large one but it drilled a lot of holes and didn't break. It did get hot but that's to be expected I think.
Scooterb
Reviewed in the United States on October 23, 2024
I had to get a couple holes for 12/2 wire thru 8 " of dolid wood, on an addition in building on my home. And it was much less money than buying it from the local Hone Depot for the few holes I needed.
Tim
Reviewed in the United States on January 25, 2024
This bit worked ok when I first started using it but it eventually broke.
D. Ward
Reviewed in the United States on April 18, 2024
The drill is fine for what I needed it for. For the price I did not expect more (I'm drilling/boring holes in my yard to set small metal posts - easier than pounding them in). However a potential buyer should be aware of the fact that the shank is 10mm, not 3/8" (slightly larger than 3/8") and the diameter of the drill is 20mm, not 3/4" (again slightly larger than 3/4"). The product as received is labeled as such in mm. As long as you know that, the product is fine. This *MAY NOT* fit a 3/8" drill, but my Makita is 1/2" so no problems for me. I took away one star for the lack of disclosure of these measurement facts on Amazon, not for a quality issue.
Recommended Products
$69.99
$ 31 .99 $31.99