Your cart is empty.
Your cart is empty.Suitable for AEG gearbox only .
Mike
Reviewed in the United States on May 9, 2024
I've built 2 DMR'S using these shem's and they run great and take a beating every time my sun and I play.
Spencer F
Reviewed in the United States on May 30, 2024
Has everything you need to shim a gearbox
Customer
Reviewed in the United States on November 1, 2024
Instead of the advertised .1, .2, .3, and .5mm I measured .17, .46, .7, and .83mm +/-.02mm. At the very least they are consistent enough for their true sizes. Time to shim a gearbox 👌
Max
Reviewed in the United States on January 21, 2024
Item as described, case is flimsy so I recommend taping down the lids upon receiving especially if you intend to put this in a bag/box.
Michael Arnold
Reviewed in the United States on September 23, 2023
I am skeptical on accuracy of sizes but I was about to shim my gear box ok so I’ll give it a pass.
Mehul
Reviewed in the United States on November 12, 2023
The shims are not the sizes they are advertised to be especially the 0.1 mm ones. Addionally they are all circles with holes punched out of them and there are some of the inner prices still in the box. As a result they all have burrs on them that make them impossible to use as they don't stack very well with other shims and dont spin very well.
Mercuri
Reviewed in the United States on August 24, 2022
So I know some shims are not what they're advertised to be so I almost always keep my calipers handy. My calibers are accurate to +/- 0.01mm so the fact that these are within that is very good. Also having the little box to store the parts is nice, even if it isn't the highest quality. I've had it pop open on occasion and have shims spill out. Also unlike the photo my box didn't come with labels on top but it's not a big issue to take a marker or make your own labels.Overall pleasantly surprised by these shims.
Colby Robbins
Reviewed in the United States on October 25, 2022
The way these are produced is by stamping them out of precise thickness sheets of metal. It's great because it's super cheap way to manufacture the shims, but i found that the all 1, 2, and some 3 shims had ridges (mainly on the inside) from the stamping process. Which meant when I would measure them they would be off.Once i went through all the shims and removed the ridges:1's were about 0.15mm2's were about 0.24mm3's were about 0.31mm4's were about 0.40mmand i had several 1's that measured more about 0.18 and several 2's that were more like 0.28mmYou get what you pay for and if you're careful it's a decent shim kit.
Recommended Products
$179.95
$ 85 .99 $85.99
$39.99
$ 17 .99 $17.99