Your cart is empty.
Your cart is empty.SHARS - 3/4 Inch Indexable 60 Degree Dovetail Cutter TDEW Insert 404-1902 P]
Customer
Reviewed in the United States on January 23, 2024
Never cut a dovetail before, but it worked perfectly.Aluminum DN ice boat mast track.
Lwood
Reviewed in the United States on February 16, 2023
Perched the 3/4” 60 degree Dovetail bit used it about 5 times on each side now need to replace the inserts but now there not available on Amazon, guess it’s just a throw away bit. Did cut decent for what it’s worth.
Customer
Reviewed in the United States on February 10, 2023
Works great better than the other brand I bought .
Dave
Reviewed in the United States on October 10, 2023
Top notch! Would definitely recommend
Bill Z
Reviewed in the United States on November 29, 2022
I don't know who inspector "W2" is but I feel like they are not doing a very good job. The "T8" wrench was more dowel then wrench. Mine did have something resembling bits installed. The tool itself does look OK. I will update my review after it cuts some chips with it.
zc
Reviewed in the United States on October 25, 2022
Gets the job done and comes with the inserts. would buy again if needed
Customer
Reviewed in the United States on October 16, 2022
it cuts much better than a HSS. cutter.
servodave
Reviewed in the United States on April 24, 2022
This was my first adventure with index tooling on the mill. I am happy with the performance of this tool. Following recommend speeds and feeds results in a very clean finish. Pictures are of AXA tool holders being shop-built. I cut a center trough in the dovetail with a roughing mill a few thousands under where the dovetail cutter depth should be and it was smooth sailing.
Recommended Products
$80.95
$ 31 .99 $31.99