Your cart is empty.
Your cart is empty.These are smooth band thin stainless clamps with zinc plated screws. Don't spend forever looking for the correct sizes. I've got them right here! These clamps are specially designed to NOT cut into your boots guaranteed! Let me guess, you lifted your Tacoma, FJ, Tundra, or 4Runner and now your CV axles are slinging grease everywhere. Yup happened to me so don't feel bad. Remove the old clamps, clean up the grease, and put the new clamps on. Good as new. No need to spend a fortune on new CV axles. Fits all Tacomas, FJs, and 4Runners Includes four small and four large clamps exactly as shown in the picture
Kristopher Swire
Reviewed in the United States on July 9, 2023
Exactly what you need for cv boots. I own band clamp tools and do use them on customer cars, but these are perfect for you offroaders out there that maintain, rebuild and repair your cv joints regularly. Even just as a trail spare, sure beats messing with band clamps in the dirt !!!
bn9130
Reviewed in the United States on July 22, 2022
Stopped leaking CV boot on my 2008 FJ after being lifted. Saves you the time of finding assorted clamps that are the right size.
Jacob E
Reviewed in the United States on March 1, 2022
Smaller clamps work fine. The larger clamps are far too large. The drive on the band was not enough to get tight around the big side of the CV boot….very disappointed.
JG
Reviewed in the United States on December 28, 2022
These did the job when other clamps failed.
Sheldon
Reviewed in the United States on February 6, 2021
There are 3 issues with these. First of all on my 2015 Tacoma there was clearance problems with the large clamp. There was .025 clearance between the screw and the lower control arm with the factory lower ball joints. I'm afraid when those are replaced these will have to come off.Next, the screw interferes with the mount for the ABS speed sensor wire mount so you'll need to bend that up about a 1/2 inch or when you go to drive your rig you'll probably break the clamp or your ABS wire.And lastly, the clamp is too wide to seat the boot in the machined groove on the CV shaft housing, so it's just a compression fit over the top which is not as secure as an actual CV boot clamp. I'll save these for some other purpose but for the advertised purpose they come up short.
Blaze Halo
Reviewed in the United States on August 6, 2020
I don't know if they are metric or what but the SAE size that fits them is an odd 1 but they work great. The dumb adapter that is required for my particular 4runner can pop out if I over tighten the larger clamps but as long as you are careful they work great.
Paul W
Reviewed in the United States on March 5, 2020
I have not used small clamps yet, but the large ones are the right size for an 06 Tundra DC.
Orlando Garcia
Reviewed in the United States on August 8, 2019
These are easy to install and strong like bull! Replaced on all 4 CV boots during a regrease. No problems so far (2 months).
Recommended Products
