Shopping Cart

Your cart is empty.

Your cart is empty.

Rubber Dock Bumper, Rectangular, Laminated, Horizontal Mount, 4 Holes, 14' Length, 6' Width, 4' Depth

Free shipping on orders over $29.99

$45.88

$ 19 .99 $19.99

In Stock

About this item

  • 4" (+1/2" or - 0") Projection
  • Designed for use at medium to high traffic loading docks
  • Fabric reinforced rubber pads cut from recycled truck tires
  • Rubber pads laminated between structural angles and secured with 3/4" rods
  • Covered by a 1-year limited warranty


Manufactured under pressure exceeding 1,500 lbs. To absorb over 80 percent of the impact. 3/8" Thick angles or flat plate are closed on each end with 3/4" tie rod. Anchor leg of angle extends a minimum of 3" beyond the rubber surface at either end and contains 2 or 3-3/4" anchor bolt holes as required (ancho bolts are not supplied) - finish for exposed metal parts is black shop primer. Full height angles/flat plates to prevent fanning of rubber. Ideal for factories, warehouses, docks: for protecting above low docks, rub rails at the sides of truck wells, special construction features to accommodate unusual anchoring conditions, (i.e. flat plate on one side to weld to dock leveler curb angle.), wall bumpers to protect against fork lift trucks.


Loyal Customer
Reviewed in the United States on August 21, 2015
Too small to be useful. Less than half the size of the bumpers we had installed. I returned mine for a refund. Otherwise, it seemed ok. Just make sure the size is what you want.