Your cart is empty.
Your cart is empty.
The Kit of the Roboto Module; assembly instructions available online.
Need a vocoder, pitch shifter, speak-n-spell effect, vibrato, 8-bit modulator and a bit crusher sounding module all in a lo-fi heavily CV controllable package? The Roboto module is all these and more (and it has a Cylon looking graphic that lights up).
Features:
- Can be in either Robot mode or Pitch mode, but not both. Handy LEDs tell you which mode you're in. The ROBOT button toggles between the two.
- Vibrato toggles on and off. Works in either Robot mode or Pitch mode.
- Robot and Vibrato CV inputs activate those modes (and deactivates in the case of vibrato) upon receiving a gate pulse. Gate pulses in these inputs are just like pushing their corresponding buttons. Transition between what is considered "off" and "on" is at approximately 2.3V.
- Rate pot/input control the clock speed in the chip. A CV input of 0-5V will mimic the range of the pot, but voltages outside of this range will push the rate setting further.
- The CV input is mixed with the voltage coming from the pot.
- The pitch pot is used to pitch the audio up or down when in pitch mode. It has 7 zones/pitches; 12:00 is normal pitch, and there are 3 steps up and 3 steps down from there.
- 0-5V fed into the Pitch jack mimic the full travel of the pot (0V is lowest, 5V is highest, normal is ~2.5V). Voltages outside this range are tolerated but won't provide any added functionality.
- The pitch pot is disabled when a plug is inserted into the CV jack.
- Roboto is fun at parties.
- IN LVL adjusts the level of the incoming signal.
- MIX:
- CCW=input signal only
- CW=processed signal only
- Current Draw:
- +12v @ 65mA
- -12v @ 15mA
- +5v @ 0mA
- Depth: 34.5mm (1.36in)
Recommended Products