Your cart is empty.
Your cart is empty.Replacement Harman Finned Igniter and Cradle Cage #3-20-677200
Karen Fogg
Reviewed in the United States on March 11, 2023
I purchased this igniter to use as a spare on my stove in November and did not need it until March. I installed the igniter and the stove fired right up. It was super easy to install after watching a video. I woke up the next morning to a stove with a dead computer board. Thankfully it turned out to be a blown fuse and the board was fine. I removed the igniter to find that the wire had a open spot on it that was in contact with the stove. After looking at my old igniter and the add from the purchase of this one I saw that the insulation that should be covering the wire is not there to protect it. I contacted the company and was told that because it is past the 90 day warranty they will not cover it. I tried to get them to cover it any way as it is clearly wrong but had no luck. Make sure to check the parts you receive. I will be searching for a different company to buy from as this one let me down.
Wild Willy
Reviewed in the United States on October 30, 2022
It bolts in place of the factory unit but is different in design. No instructions but pretty self explanatory. There’s a little metal tab that needs to be bent after installing the igniter in the cage in order to retain it. I just installed it today and it works just fine in our Harmon pellet stove. It arrived ahead of schedule and was well packaged. No complaints
lynn riffel
Reviewed in the United States on October 21, 2022
The part was about half what we would pay at our local stove store. Grea value.
David J. Willey
Reviewed in the United States on October 17, 2022
you cant turn the inside of the cage around, so the plate on the top with the screws in it is useless. igniter works fine cage not so good.
Brenda Green
Reviewed in Canada on January 31, 2021
Easy to install
Customer
Reviewed in Canada on January 10, 2021
Only half the of the part came in. The add says cradle and igniter. Only the igniter came.
Pat Fagundes
Reviewed in the United States on November 6, 2020
The plate that holds the ignitor in was missing from the package as shown in the picture above. The ignitor worked great and fortunately I was able to use the plate from the old assembly to hold the ignitor in place.
Bill
Reviewed in the United States on November 16, 2020
Tabs on cradle are too large to fit in slots provided. I don't have tools small enough to enlarge the slots. Thought I could return item but company did not respond to my emails.
steve
Reviewed in the United States on November 11, 2020
Part was exact replacement and received part faster than expected
ddev
Reviewed in the United States on October 3, 2015
Fits perfectly in the Harman P43 and performs well. The stove itself provides very tight clearances for placing the unit but that just requires a bit of trial/error to get everything back together. Note the orientation of the installed igniter before you remove it. You'll want to pull the 2 stove wires forward gently then disconnect the igniter wires from the stove wire connectors. Connect the igniter wires and feed the wires/igniter into the stove opening. Go to back of stove and gently pull the 2 white wires to the rear. Stop when you hear the new igniter cage rattle. Position the igniter cage w/ igniter and attach with the 2 orig. screws. Check that the wires are feeding out through the air inlet tunnel - adj. if necessary so they're well below the actual burn chamber.
Recommended Products
