Your cart is empty.
Your cart is empty.Product Description
Description:
- Current Rating 26 AMPS
- Fits Models : Condor MDR 11/11 EA.
- Cuts in at 120 PSI - Cuts out at 155 PSI.
- 1/4" Quick disconnect fitting for check valve line,¼” FNPT Inlet 4 Port.
Note:
- The pressure range of 125-155 PSI can be adjusted according to specific requirements. This makes it applicable to various applications such as air compressors, water pumps, gas systems, hydraulic equipment, and more. You can customize the working range of the pressure switch based on your specific needs.
- This pressure switch features a reliable design and high load capacity. With a rated current of 26 amps, it can handle heavy current loads, making it suitable for high-power devices. Additionally, it supports voltage options of 120/240 volts, catering to different power supply systems.
Taller Ric.mar
Reviewed in the United States on September 14, 2024
Exelente
CHAD E FARR
Reviewed in the United States on December 3, 2024
The description of this item says it is a 'Replacement for Condor MDR 11/11'. It will replace this pressure switch, however it needs to be adjusted and it DOES NOT include instructions for adjusting it. The original pressure switch on my air compressor was a Condor mdr 11/11 and it had a cut-in pressure of 80 and a cut-out pressure of 120. After installing this replacement, I cycled my compressor on, and it exceeded 160 PSI before the POP-OFF valve opened up to relieve pressure. I found the model number of the new pressure switch printed on the inside after removing the plastic c cover(LF19-4H). A quick google search and I found some adjustment instructions without pictures. I circled the adjustment screw in the picture that is included with this review. I turned the adjustment screw counterclockwise, six times. This yielded the result I was seeking. The pressure switch now cuts in at 80 and cuts out at 120.
Shawn bendt
Reviewed in the United States on December 14, 2024
Works perfectly, fully adjustable
Francis Robertson
Reviewed in the United States on November 5, 2024
Ok
Debby4576
Reviewed in the United States on October 26, 2024
Did not come with the clamp that secures the electric cables. Did not come with the plastic part that allows the small aluminum tube to be connected. Also felt cheap compared to the Condor mfr 11 that it replaces especially the plastic switch itself. Too easy to break.
Colorado Jim
Reviewed in the United States on October 15, 2024
There is no way to secure the wires in the contact switch. If you use terminals, they are way too large and will not fit anywhere no matter what you do.This is not a direct replacement for a condor switch. I am quite certain that the person that designed this has never attempted to hook it up.It comes with absolutely no instructions on how to set the trip pressure either. Well actually, it comes with absolutely no documentation.Good luck.
dm
Reviewed in the United States on January 26, 2024
Needed a new one for shop compressor and works prefect
Ricky S.
Reviewed in the United States on April 1, 2024
The line posts aren't large enough to accept proper sized wire connectors. There is only ONE cable access hole instead of two that are needed to connect the correct cable. No ground screw was supplied, and the threaded hole doesn't accept the actual mdr 11/11 Condor one. The on/off mechanism doesn't allow for adjusting the pressure adjustment, because with the cover off the switch disengaged. Also, no cable retension was included, and no instructions on how to adjust pressure cutoff point. THIS UNIT IN NO WAY REPLACES THE CONDOR MDR 11/11. Now I have to drive an hour to send the unit back. They owe me gas and time.
Recommended Products
$190.00
$ 92 .99 $92.99