Your cart is empty.
Your cart is empty.Product Description
Three flats on reduced shank
Reduced shank drill expands the size range capacity of a portable drill chuck. Three flats on shank eliminate bit spinning in chuck.
118 degree split point
118 ° split point starts drilling immediately requires less force and eliminates “walking” across the working surface. Scientific design, sharp and wear-resistance.
D. K. Numinen
Reviewed in the United States on January 8, 2025
Cut well true to size
james b
Reviewed in the United States on January 17, 2025
used to drill truck frame for snow plow mount. shaft bent while drilling 4th hole. would work great for wood or lighter application. you get what you pay for. spend a little more and your work won't be interrupted for two or three days waiting for a replacement.
Forester02
Reviewed in the United States on August 1, 2024
Cuts clean
Greg K.
Reviewed in the United States on July 1, 2024
Worked pefectly. Much better that the other tools I tried (Hole Saw, wood bit). Very solid construction.
Just Plain Tom
Reviewed in the United States on June 12, 2024
Well made. Sharp. Comes with a storage case. Great Value.
Brent Esker
Reviewed in the United States on February 22, 2024
Needed to make a larger hole, in 1/4" steel (22mm to 23mm}, 4 holes total. First one did ok. Second hole had a lot of trouble, but finally went through. 3rd & 4th holes, went in about 1/16" and that was it. Bit kept dulling and required sharpening.
Scott
Reviewed in the United States on December 2, 2023
Fast delivery, exactly what I needed.
Bethzaida Crespo
Reviewed in the United States on October 31, 2023
I got this specific size in mm because I was tired of drilling up to the size then sanding to get my actual size. I did it once but that’s a chore. I work with SAE but my project required mm.The size of the bit I received is not 21mm. That’s the main reason I purchased this bit. Attached photos show various undersized measurements I took at several areas on the bit from the end of the bit tip to the start of the shank.The 3 flats on the shank are so slight it may as well be round.I had trouble getting the bit to chuck up and had to really hold onto the bit to get my chuck to tighten around it. I do not have this issue with my Fisch twist drill bits.The cut isn’t smooth at all and left choppy fragments. Albeit sanding is usually required after any drilling, more was needed to sand than should have been.Why can’t any of these MIC products be of good quality? And we continue to buy….I will be returning these and looking elsewhere. And so far I’ve found nothing here.
Recommended Products