Your cart is empty.
Your cart is empty.Product Description
Car Radio Wiring Harness Connector Select for Ford Vehicles
Choose RED WOLF, Easy to Use!!!
Pure copper core made
RED WOLF wire harnesses adopt pure copper as the material, Strong conductivity, Safety and reliable during use
Shamzy
Reviewed in Canada on March 1, 2025
As described
Bryan C.
Reviewed in the United States on February 23, 2025
The wire harness worked exactly as expected, no surprises! I use the heat shrink solder connections to be sure they stay together. Easy to install and a great value.
Jose
Reviewed in the United States on February 14, 2025
Didn’t meet the expectations at all
kmac
Reviewed in the United States on January 15, 2025
Easy to wire up
Shawn Bellegarde
Reviewed in Canada on September 18, 2024
Ordered this and was the wrong onefor alil newer Escape lesson learned
Sébastien Côté
Reviewed in Canada on May 25, 2024
Acheter pour mon mustang pas besoin de l'adaptateur pour l'antenne mais manque la diode pour le kit mach 460
WD
Reviewed in the United States on May 23, 2024
This is perhaps my lack of knowledge of the system in my car. However I read in the description it would work with 2009 Mustang however it does not. The back of my shaker 500 radio has three wiring harnesses not two. So this left one harness not used. I plugged everything up to my after market radio and it would not power on. I plugged the shaker 500 radio back in, only using the two harnesses which this products fits, and it would power on, but nothing else, no audio, no cd, no nothing, just the clock. In doing further research it appears I need a harness which can accept all three of the factory harness, not just two. Overall, the product is probably great, the wires are of good quality and the harness does plug into the factory harness well. However if you have an 2009 Mustang with the shaker 500 and there is three wiring harnesses on the back of the radio, this product will not work.
Janet Talley
Reviewed in the United States on December 29, 2024
I replaced the CD player with a Sony XAV-AX4000 7-Inch Multimedia Receiver, which was also a perfect fit. I soldered the conversion kit to the Sony wiring harness. It was nearly a perfect match, even the colors matched. The conversion kit had a few extra wires (4 brown wires) for components that I did not have. I just bent them over and taped them off.
James
Reviewed in the United States on December 17, 2024
Soldered my radios connector to this adapter and it worked like a champ. The connection was an easy fit. No altercations. Went with the manual and the wire colors matched up fine. Instructions were accurate. They even told me to ignore the brown wires. They’re not in use, but at least they are present if you need them. Antenna adapter was spot on. It all worked great. Value for the money is excellent.
GizmoRabbit
Reviewed in Canada on November 12, 2024
This harness was useful for my 2008 Ford F450 superduty. I swapped out the stock radio for a mid 2010s JVC I had kicking around my garage. The "smaller" adapter was of no use to me, and in fact would have been incompatible with the "smaller" cable interface that I have left orphaned in the back of my dash. I'm not sure what all those extra cables were for, LOL. I think at least 3 of them were for a factory 1/8" aux input on my dash that my head unit has no input for anyway. Of particular note is that the antenna adapter works. That is the main value-add to this package for me. In short: this worked for me. I have never done a car stereo install before and lead lengths and wire map included with this package worked well for me.
cptnamr7
Reviewed in the United States on July 10, 2023
This will not 100% work for a 2010 Focus with sync, though I don't believe Sync is the issue. The red (switched power) wire doesn't align to anything on the car. But there's also NO SWITCHED POWER anywhere in the radio on this vehicle. (There's constant power to the radio face and a relay inside that triggers when the car is started to give it to the radio) My only option was to fuse tap off the sole fuse with the behavior I needed. (Remain powered until door opens) Of which the car has 1- ambient lighting. I was able to locate a wire from 5 of the 8 steering wheel buttons (grey/yellow and the blue/white to ground) but this harness didn't have a wire in the grey/yellow spot, so had to move a pin is all. Never did figure out the remaining 3 buttons and gave up after I blew a fuse. Found a wiring diagram that implied they required some additional components and I was installing a full touch screen so didn't care anyway.Only adding this review to help anyone else facing this same situation. Couldn't find a single harness anywhere that stated it was for this car and now I know why. It still worked, but required modification and a fuse tap. The other options are like $150 and that's just dumb.
DD
Reviewed in Canada on October 1, 2022
Unless your install is absolutely basic don't waste your money.Update: RedWolf refunded my money for this. I am impressed with their customer service and the lengths they went through to correct this. Although the product didn't work for me, they reviewed their claims about this product and altered it accordingly. I can't give 5 stars for the product, but their service was great. So I'll split the difference.
John Doe
Reviewed in the United States on October 9, 2020
This harness contains two jacks. The smaller of the two did not fit the smaller of the two factory plugs in my 2008 Ford Escape. The attached photo shows the smaller of my plugs (top left, red face), which was too wide for the Red Wolf jack (top right). The big jack and plug fit just fine. I’m also attaching a photo of the instructions that came w/ the set. If I can somehow resolve this problem, I will post an update. They promptly accepted a return and refunded my payment so I'm upgrading the ratings to 4 stars.
Recommended Products