Your cart is empty.
Your cart is empty.4 Premium ball mount threaded studs Designed for a perfect fit (for 10 mm ball sockets); length 1.33" (37.7 mm), threaded shaft length approximately 1/2", ball stud size 10 mm Great for RVs, campers, and home or shop projects; Fits gas springs (props/struts) with 10 mm ball sockets Premium Automotive Grade Coated Steel.
nohsmega
Reviewed in the United States on July 21, 2023
1 of the loop holders on rear GTI latch snapped off. Aftermarket ones were expensive ( think ECS has a kit of 2 50$ or more can't remember exactly but OUTRAGEOUS!! ). Took off the arm part of the lift,Filed down the broken part to a flat surface, drilled the correct hole, slide thru, tighten nut, put it all back & it was better than factory!!!
Ronald Romero
Reviewed in the United States on October 4, 2022
It was exactly what I needed
JR
Reviewed in the United States on May 23, 2021
Needed one stud for my windshield wiper arm thats been discontinued. Drilled out the old stud and welded this one in. Works PERFECT.
Lazarec C.
Reviewed in the United States on May 10, 2021
I use the item for my hood struts and they were what I ordered
Jason Naylor
Reviewed in the United States on November 4, 2021
Good quality part, wish it was a bit less expensive, but it was just what I needed to fix the lift gate on my 2007 Honda Odyssey.The factory stud was plastic and had broken off and the liftgate strut was bent in an attempt to close the gate afterward.There is a nut included with each stud that was unnecessary for my application but this was exactly the part I needed.I was easily able remove the old stud and install this part and the replacement liftgate snapped into place perfectly.
Jeffrey Bethea
Reviewed in the United States on May 31, 2020
MINIMUM AMOUNT OF WORK TO INSTALL. USED ON A TRUCKREAR WINDOW
Natasha Arnold
Reviewed in the United States on May 13, 2020
As expected but silver not black
D. H.
Reviewed in the United States on February 28, 2020
Listed as a 10mm ball but measures at it's widest point at 9.84mm. The old ball stud I'm replacing measures 9.96mm so the new ball fits into the joint loosely and can be pulled out even with the retaining clip on.
Recommended Products
