Your cart is empty.
Your cart is empty.Product Description
Dimensions
FRANK DIAS
Reviewed in the United States on February 20, 2025
good
Robert S Ferguson
Reviewed in the United States on January 22, 2025
This stuff is great for insulating under the trailer for cold weather camping. Warm it with a heat gun and it will mold to almost every curve and bend. Just hold it in place until it cools and it retains the shape.Their expensive tape doesn't work very well. The day after I put it on, it was all laying on the ground.
LSK
Reviewed in the United States on September 4, 2024
I used it for the underbelly of my RV.
Bernard D. Ritchie
Reviewed in the United States on September 15, 2024
I had removed the factory underbelly to run some wires, but the old one wasn't reusable. This is an exact replacement, which I installed with self-drilling screws and fender washers rather than powder driven fasteners. It'll make life easier in case I need to get back in there. I also took the liberty of rerouting some ductwork, tidying up wiring, and adding 1/2 in polyiso foam under the coroplast.
Christy Hawes
Reviewed in the United States on November 2, 2024
No issues with product. Used for intended purpose.
Maranda Bowers
Reviewed in the United States on September 1, 2022
We never got the first one we ordered. Finally, almost two months later, a new roll was shipped out.It is finally installed under our toy hauler and it is almost the perfect fit.A bit hard to maneuver around hoses/pipes but a better quality than the original underbelly protection.
SJ
Reviewed in the United States on December 27, 2021
We damaged the underbelly on the travel trailer on our last trip to Texas and back, I think we went over some piece debris on the Interstate and it bounced up and knocked out a bunch of it or something. I used a bunch of self-tapping ⅜" screws with pilot holes and this worked like a champ. I removed the old stuff for half the length of the RV and started this with about 1 foot of overlap to the old stuff at the half-way point to the rear. I just rolled it out and this went on surprisingly easy. I think I had guessed it would be about a half-day of effort, and frankly, I was done in about an hour or two. Very high-quality stuff, some kind of composite, I expect it will be good for another 50,000 miles or so like the OEM stuff it replaced.
Recommended Products
$72.99
$ 35 .99 $35.99
$26.24
$ 12 .99 $12.99
$39.99
$ 19 .99 $19.99