Your cart is empty.
Your cart is empty.Keep the ABS Sensor ring and remove the bearing from the axle,easy to use.
Chad Smalley
Reviewed in the United States on February 5, 2024
Didn't fit my press
Mauricio
Reviewed in the United States on October 20, 2024
Used the tool to replace my wheel bearings on my 2019 Tacoma TRD Offroad. Worked as advertised.
scott fisher
Reviewed in the United States on January 8, 2024
Worked great on a 2018 Tundra. Fast shipping.
robert russell
Reviewed in the United States on April 29, 2024
The quality is good for the price. It does the job and I think that it will work multiple times without any problems from failure. It's not like the high end tool, but unless you are going to be using this tool several times a week it should perform well. You will need to make a bushing for use at the top of the axle to prevent the axle shaft from going to the side as the axle hub bearing is pressed off.
Anthony
Reviewed in the United States on March 9, 2023
Great welds, quality steel I yet to run into any issues.The tools works all the way up to a 2022 Tacoma, or 4runner
Craig
Reviewed in the United States on October 15, 2023
Used this to change rear axle bearing hubs on a 2011 Tundra. It was strong enough for the job and well made. However, the one flange and mid-shaft collar required modification to work the current Harbor Freight 20 Ton press. Other reviewers noted the same issue. The flange and collar needed to be narrowed to fit through the 4" wide press apron. It is not the fault of the manufacturer because it will work as supplied in traditional commercial shop hydraulic presses. For serious DIY folks that use Harbor Freight presses, some modification is required. Plan ahead.
Doug
Reviewed in the United States on March 31, 2021
Worked great on my 2017 Tundra rear axle bearing replacement in combo with the ABN 6878 bearing puller and two 5/8" - 18 tpi bolts to pull the bearing race off. Rather than modify the tool to fit in the Harbor Freight press, I modified the press to work with the tool.
Craig
Reviewed in the United States on December 7, 2021
Great product. Fit perfectly and bolt up right to the bearing assembly. Made for and easy press out of wheel bearing. Recommend this product for Toyota truck bearings.
Recommended Products
