Your cart is empty.
Your cart is empty.Product Description
30A Brushed ESC Without Brake
- Function: forward,reverse
- Suitable for 1/16 18 24 Car and Boat Tank
- This ESC can work with 130/180/260/280/380 Brushed Motor
- Voltage support: 4 ~ 8v can be directly on the 2s lithium (7.4V).
YoungRC RC 30a Brushed ESC Without Brake
This ESC can work with 130/180/260/280/380 Brushed Motor
Without Brake
Specification:
- Function: forward,reverse
- Material: Synthetic material
- Dimensions(L*W*H): 40*19*10mm
- Current (A):30A
- BEC :5V 1A
- PWM:8K
- Input signal ：PPM
- Driver frequency：2KHz
- Ni-Mh/Ni-cd :4-7cell
- Continuous current 10A Max 20A< 30s Pulsed 30A< 5s
RC 30a Brushed ESC Motor Speed Controller
Package List:
2x 30A ESC without brake
Ethan Telford
Reviewed in the United States on February 21, 2025
Esc works fine. It is advertised as NO BRAKE! But it dose have a brake so if you shearched for the ones without a brake and thought you found them do in fact did not.
K
Reviewed in the United States on August 3, 2023
Update:They kindly sent a replacement and it works fine.————Got erratic and unpredictable behavior from the first one. Swapped in the second one and everything was fine. Not ideal and kind of a waste. Seems a common problem, unfortunately.
Cecil Harrison
Reviewed in the United States on November 9, 2023
I ordered this item for a robot I built and it worked great. 18 months later I ordered another set but they did not work. The manufactor went above and beyond to help me fix the problem even sending me a new set of controllers for free. Turns out the problem was my fault as I ordered the wrong part. They were willing to send me a correct set again for free. I build robots as a hobby and will certainly buy from this manufacture again.
Emmanuel
Reviewed in the United States on June 9, 2022
The media could not be loaded.
Sam
Reviewed in the United States on October 19, 2022
These little guys are perfect for my newest project, and look to be built very well. I like the fact that it has a switch that works for the BEC, so that I can keep the main power on while turning off parts that aren't being used at that time. Aside from that, the ESCs work as intended, will buy again.
Xander
Reviewed in the United States on March 24, 2021
These work great in my fairyweight (150g) combat robot powering n20 gearmotors.The power switch behavior is a little weird, it seems to only control the BEC, so if your receiver is powered by another BEC watch out -- the switch can be off and the motor will still go.However if you're powering your motors via the receiver like I do, with the switch off the LED on the ESC will turn on and dim and everything but the motor won't turn until you turn on the power switch. Took me a while to figure that one out.For what I'm doing I can't use that switch anyway so I just removed it as well as the leads for the battery, which meant I had to short the pads that the switch was on. Easy peasy. Removing those leads really makes the package much smaller too so it's worth doing if you're not gonna use them.
Eric
Reviewed in the United States on October 12, 2021
Seemed good until you run it. I bought 2 both are igzactly the same. Output power is correct. Problem is anything past half throttle becomes full throttle and no matter what you do the car is in full throttle till you can turn it off. Goodluck with that. Hopefully you can run fast enough or a flying rc, yah sounds fun. Might as well just hook motor to battery.
S. K. Howell
Reviewed in the United States on July 21, 2019
I used both ESC in a small RC FPV tracked vehicle driven by 4 small dc motors (like these: https://www.amazon.com/gp/product/B07CJZ58G5/ref=ppx_yo_dt_b_asin_title_o03_s00?ie=UTF8&psc=1 ), 2 motors to a track. Each ESC drives 2 motors in parallel, powered by a 2S 2200mAh LiPo battery & controlled by a 6 channel FlySky receiver. I use a discrete BEC attached to the battery to provide a power source for receiver & camera.They work fine running the motors both forward & reverse from minimum to maximum throttle & I have seen no indications of heat buildup issues even after protracted full throttle operation.The only component that doesn't seem to work is the on/off switch. The ESC's behave the same regardless of whether the switches are in the "on" or "off" position. I assume the switch was intended to enable/disable the ESC, but no instructions were provided so that is just my assumption at this point. In any case, this does not impact my use so I am not deducting any stars from the review.
Recommended Products
$124.99
$ 48 .99 $48.99
$104.39
$ 48 .99 $48.99