Your cart is empty.
Your cart is empty.This distributor cap kit contains the cap, rotor and cap gasket. Fits Marinized, V8 MerCruiser Engines made by General Motors with Thunderbolt IV and V HEI Ignition Systems. See your owner’s manual for replacement information and directions. The Quicksilver brand is the leader in delivering uncompromising engine oils, parts and accessories to the marine industry for over 65 years. Quicksilver is the premier supplier of Mercury Marine Original Equipment replacement engine parts, oils, and accessories, but also works to serve all Original Equipment brands in the marine and powersports industries. It has earned a loyal following by providing the highest quality products that are tested through some of the most rigorous environments and testing procedures. No aftermarket company comes close to the level of research and design as Quicksilver; buying Quicksilver is buying performance, protection and peace of mind.
C. Glazier
Reviewed in the United States on August 7, 2024
Exact fit and included the paper gasket. Kit does not include new screws.
Jarod Gatson
Reviewed in the United States on June 29, 2024
Replaced my old one with this one and had no issues. It does not come with screws so don't throw your old ones away. It works as it should.
Max
Reviewed in Canada on June 27, 2024
I found bass swarf embedded on the inside of the distributor cap, which would cause misfiring. I was promptly sent a replacement.
Customer
Reviewed in the United States on November 12, 2024
The cap cracked and caused a miss 4 days out of returnable. A lot of money for one month of use.
Ycalve
Reviewed in Canada on September 15, 2023
Had a power and misfire issues…change the part with this one and all is working perfect. My engine is a mercruiser 5.7L black scorpion
Steven C Valaitis
Reviewed in the United States on August 7, 2023
Great OEM quality and a good price
Daniel B.
Reviewed in the United States on July 29, 2023
Works great. Not like the cheap ones but didn’t cost a fortune
meg ryan
Reviewed in the United States on October 16, 2023
Product was as pictured and worked great for the boat.
S3adrag0n
Reviewed in the United States on May 2, 2022
Bought it to replace older corroded unit. Fit perfectly, but you'll have to use your older screws as the unit doesn't come with them.
Tom Feeney
Reviewed in Canada on July 8, 2021
Pricey cap but works well.
Blair Hockin
Reviewed in Canada on July 1, 2021
Good quality cap has brass terminals,
Graham H.
Reviewed in Canada on October 22, 2021
perfect
P. H. Johannsen
Reviewed in the United States on October 12, 2020
So, I needed TWO caps and rotors since I have twin motors in my boat.....but there was only ONE Quicksilver OEM set in stock...so I ordered it, and then ordered a Sierra kit as well....and thought I would compare, and see if there is a difference! (Next season as I am on the dry for the season now...)Well right out of the gate, the Quicksilver product seemed better quality! The cap was just about the same as the Sierra, but the ROTOR was definitely better quality!The Sierra had a SCREW that held on the contact point of the rotor, where the Quicksilver was riveted! Also the rotor BASE was more substantial than the Sierra! Heavier, better fit and finish, plus the rotor shaft was BOLTED (Via three small bolts) to the base where the Sierra was held in with three screws! (They didn't even look to be stainless!) I am sure both are "OK" but the BOLTED set up looked a lot more sturdy and better quality!Why four stars? The OEM kit I received did NOT include new cap mounting screws!!!!! Not a HUGE deal...but one of my screws was bent, and I needed to replace it!So, I have not had it on the water yet so I may change my idea either way if one does not perform, but just based on initial quality, and workmanship, I give a nod to the OEM over Sierra! The Sierra didn't look "Bad".....just not to the quality and fit and finish compared to the OEM.......
Recommended Products
