Your cart is empty.
Your cart is empty.This is a new, top quality rear brake backing plate for the Honda 1988-2000 TRX 300 FW 2x4 & 4x4 (this is for the utility model with the front and rear racks). This is an excellent quality part that is made to meet or exceed OEM standards. This brake backing plate includes the center bearing & seal already pre-installed. Keep in mind, if you need bearings and seals, brake shoes, brake drums, rear axle, axle nuts,---check them out in our store. Don't be fooled by less expensive backing plates that are cheap quality Chinese parts. This backing plate is a direct replacement made in Taiwan
danwaynewilliams
Reviewed in the United States on March 24, 2021
the factory part is no longer available, so an aftermarket part of quality is welcome.
droop
Reviewed in the United States on January 22, 2021
Received on time. Mine did have a small crack in the casting. I contacted the seller and they did offer me to return it, which I did not because I was told the product was on backorder. I kept it because I needed it. It does come with the 4 mounting studs, the bearing and axle seal installed. You will need to replace the large O-ring that seals the cover and the 3 gaskets for the brake cam. Mounting nuts are not included either so keep your old ones. Also keep your old drain bolt, washer because it doesn’t include those either, or the 6 drum cover bolts that go along the outside. Other than the crack in the casting I would rate 5 stars. I’m sure if you have time to wait you could get a refund if yours is cracked but availability seems to be a problem. This appears in every way to be the same one offered and sold by G&H atv supply in Tennessee.
Crystal Lister
Reviewed in the United States on August 6, 2019
the product was exactly right awesome fit for my 1990 honda fourtrax trx300 fw.
Robert
Reviewed in the United States on July 9, 2019
It fit my 300 fourtrax just like it was a factory part. You do have to put the brake cam from the old one but just make sure you pay attention to how the little control lever is positioned before you take it apart. It will save you some headaches.
Joe
Reviewed in the United States on July 8, 2019
Perfect fit
kelly neal
Reviewed in the United States on December 16, 2019
As advertised. Fit like OEM.
Devon Zinter
Reviewed in the United States on September 21, 2018
One of the mounting bolts stripped when putting but on. But the other 3 are still good
Kelly Kimble
Reviewed in the United States on May 21, 2018
Fit perfectly. Studs and bearings were included which is great because I thought I might need to put them on it. My biggest problem assembling it was getting the brake arm and spring on. There is probably a trick to doing it right and easily, but I ended up fighting with it for an hour.
Recommended Products
$56.56
$ 26 .99 $26.99