Your cart is empty.
Your cart is empty.Nice tool meet a lot of use: Adjust the arms to a suitable distance through the screw, then insert pins into the corresponding slots. Used to fix, install, disassemble, screw and unscrew any accessories or part on a vehicle in the proper size. Fit any bike, motorbike, moped and scooter. Great for scooter clutch, trim cylinder, motorcycle flywheel, hydraulic gland, transmission gear, variator, hub, etc.
Ritchf
Reviewed in the United States on February 18, 2025
Tool requires some modification depending how much room you have access to holes in pulley.Requires shortening and grinding pins down to fit holes in the pulley. Would benefit from having a ratchet mechanism to hold in place for one hand operation.
Robert B
Reviewed in the United States on January 4, 2025
I bought this tool in anticipation of using it to stabilize the flywheel fan of my motorcycle as I attemptedto loosen the bolt on the other side. However, when I tore down the engine cover and got to the flywheel, I found the fan had no holes in which to insert this tool. Therefore I never got to use it.Having said that, it appears well made, heavy enough, and quite capable of doing its intended job in an appropriate situation.
Homero Esis
Reviewed in the United States on January 26, 2025
Excelente
Alan MacNeilan
Reviewed in the United States on September 29, 2024
This spanner helped hold the A/C magnetic clutch plate still so the 10mm bolt holding the plate against the compressor could be removed on my 2014 Subaru Crosstrek. It's variable so you can use it on other work.
robinfla
Reviewed in the United States on December 1, 2024
Broke immediately. Sent back. Only use for very light extraction.
Gabriela
Reviewed in the United States on November 29, 2024
Muy util
kenny7
Reviewed in the United States on November 21, 2024
Perfect
SM
Reviewed in the United States on October 5, 2023
This is just okay. It should serve for most moderate to light uses, but super heavy duty I may be concerned on how it will fair. The metal is bare, no big deal, but it is already getting a tiny bit of surface rust in the edges near welds. The welds are just tacks and not all the way round so that is my main concern for heavy duty work. Otherwise for moderate jobs it is probably fine.
Recommended Products
