Your cart is empty.
Your cart is empty.3.7 out of 5 stars
- #314,327 in Toys & Games (See Top 100 in Toys & Games)
- #18 in RC Vehicles Radio Transmitter & Receiver Sets
Product Description
[Receiver module ] Product Model: WL101-341
WL101-341 superheterodyne wireless receiver module is receiving UHF ASK demodulators support ASK and OOK modulation. The receiver module has high sensitivity (-110dBm),Low-power performance, along with high dynamic range (greater than 60dB). Module uses highly integrated chip, built front-end low-noise amplifier,Mixers, filters, frequency synthesizer circuit, etc., can maximize the signal optimization.
Product Features
1.Support ASK / OOK modulation, the receiver sensitivity of -110dBm;
2.Operating frequency: 433 MHz, bandwidth of about ± 150KHz;
3.Mains input voltage range: 3.0V-5V;Working current: Type :5.0mA (Requirement:VDD=5V) ; Type :6.0mA (Requirement:VDD=3V)
4. Quiescent Current: 1uA
5. Low power consumption;
6. Good selectivity and spurious radiation suppression, and easy to pass CE / Fcc international certification;
7. Good local oscillator radiation suppression, multiple receiver module to work with (ie, more than single income) and will not interfere with each other, used together without affecting the receiving distance;
8. Multiple transmission rates, the general module for 2KHz, up to 10KHz;
9. Temperature range: -40-85°C
10. Ultra-small size of 30.25 × 8.5 × 1 (mm)
[Transmitter Module] Product Model: WL102-341
WL102-341 transmitter module is UHF ASK modulated transmitters, support ASK and OOK modulation. The transmitter module integrates an analog PLL circuit and ASK modulation circuit, with a high level of integration, etc., can be applied with a short-range wireless communications. Operating frequency 433MHz, transmit power is greater than 11dBm.
Product Features
1.Support ASK / OOK modulation, transmit power is greater than 11dBm;
2. Operating frequency: 433 MHz;
3. Mains input voltage range: 2.0V-3.6V;
4. Low-power consumption shutdown mode current is less than 1uA;
5. Transfer rate up to 20KHz;
6. Launch distance :20-200 meters
7. Size: 16* 12 * 1mm
8. External antenna: 25cm ordinary multi-core or single-core line
9. Temperature range: -45-85 °C
[Receiver module ] Product Model: RX500
RX500 is a single-chip ASK/OOK RF receiver module with high integration and ultra-low power consumption.The high-frequency signal receiving functions are all integrated on-chip to achieve the most reliable receiving effect with the least external components and the lowest cost.
The working voltage range is 2.2V~5.5V, the very high sensitivity is -108dBm, and the ultra-low working current is 2mA, making it very suitable for a variety of low-power requirements.
Perfectly compatible with various super regenerative receiver modules
Complete Monolithic UHF Receiver
Data rate: up to 5kpbs
Standard CMOS interface control and decode data output
RF antenna radiation is very low
The most economical peripheral device design solution
High integration, simple peripheral, stable and reliable
PIN Function
1.ANT Antenna pin
2.VDD Power Input
3.DO(DATA) Data output pin
4.DO(DATA)Data output pin
5.GND Power Ground Pin
Ronald V.
Reviewed in the United States on January 22, 2025
I was concerned when the packaging looked like it had been wet. The boards were in plastic, but the receiver board had a white crust on it. I gave it a try anyway…no joy. It didn’t work
Customer
Reviewed in the United States on August 3, 2024
Had to do a bit of digging to get the correct software. Google for 'arduino serial communication'. This is the only transmitter/receiver pair that I have found, that works.
MaxVideo
Reviewed in the United States on November 7, 2023
I am controlling this with an Arduino using the Virtual Wire library. There are many such receiver modules like this out there for receiving on 433 or 315 MHz. Some work great. Some do not. This one works well. I could get a solid 100 foot reception range from a FS1000A transmitter. People say they can get hundreds of yards out of these 433 modules, but in practice, unless you have a large dipole antenna, a 100 feet for accurate reliable message passing is about it, especially if you need to go through some walls or have other interference in the area. The antenna is importanrt. Don't use the coily little wire that comes with it. That will limit you to about 10-15 feet of reception. The whole subject of antenna design for these things is a complex subject I can't go into here. Suffice it to say, I found 3 different brands of 433 superhet receivers that work well with Virtual Wire on an Arduino, and this is one of them. I'd buy them again.
Derek B. Rosen
Reviewed in the United States on October 25, 2023
These are the "better" ones. At least for Arduino / ESPHome projects. Avoid the cheaper, more common (to find) ones available. Those generally don't even come with an antenna. You get 1–2-inch range. Even with an antenna the other type have like 1 foot range. Look for "Superheterodyne" or get these.I used these to create a "Harmony Remote" replacement on ESPHome with Home Assistant. A generic RF remote triggers Home Assistant to control media devices via a Broadelink RM4 Pro.
R S.
Reviewed in the United States on April 16, 2023
These worked fine with the Arduino RCSwitch library. Mine had the same markings as another reviewer that said they were 315mhz, but I can confirm that mine are 433Mhz even though the crystals have different numbers than the picture in the product listing. They have a slightly longer range and perform a little better than the cheaper 433Mhz sender and receiver units you see. Solid performance at 150' and worked to around 200' (no obstructions) with the supplied antennas. Max range was 200' but a little spotty beyond 150'. Worked from everywhere in my house, going through 4 walls and a floor.
TheDellroy
Reviewed in the United States on June 12, 2022
I tried it for a couple different sensors, but it does not work. Little documentation
Vector Sigma
Reviewed in the United States on March 18, 2020
Compared to the other less expensive units that come in a lot, this RX/TX combo works beautifully. Use it with the RCSwitch library and you're in business! The antenna and the crystal make a WORLD of difference. Wasted an entire day trying to get the other units to work with custom antennas of various sizes with no success. The 3.3V and size make this a perfect battery project. Use this in conjunction with a PIR + Doppler radar and you will have the perfect human detector sensor.
Timothy G.
Reviewed in the United States on January 11, 2020
The chip that I got was NOT 433.92MHz (which is what is shown in the description). It is only 433MHz.The project I was using it for was not receiving the 433.92MHz signals but was receiving a 433MHz signal I had.The chip did work (was not dead on arrival) so I gave it 2 stars for that. Unfortunately I can't use it for what I need.
Recommended Products
$32.99
$ 15 .99 $15.99