Shopping Cart

Your cart is empty.

Your cart is empty.

Putco Molle Mount Plates, 4 Piece Set

Free shipping on orders over $29.99

$38.47

$ 16 .99 $16.99

In Stock

About this item

  • Pack Quantity: 4 Piece Set - Heavy Duty Construction PA66/GF30: Manufactured out of fiber-reinforced polymer and rated for up to 300lbs of holding capacity. All hardware Included: Each Molle Plate Includes the 1/4 inch Bolt and Washer.
  • Made Specifically for Putco Molle Panels (Does NOT fit any other brand ). These Molle Mounts are a direct fit mounting solution for accessories clamps like Quickfist and Kolpin but also other accessories like HiJack Maxtrax, RotopaX, and many others. Simple Install onto Putco Molle Panels: No drill, No cutting, Bolt-on installation.
  • Dimensions: 2.2" by 1.8" and super-low profile in thickness at only 14mm. Get just the right quantity you need for your equipment: These kits are sold as Sets of 4, 8, 12 or 16 pcs.
  • Simple Install onto Putco Molle Panels... No drill, No cutting, Bolt-on installation (NOT recommended for any other brand).
  • Warranty: Built to last years of heavy loads in rough terrain with Putco's 3-year warranty. Designed in the USA: By Putco Inc. in Des Moines, IA.


NA


Lauren Van Scoyoc
Reviewed in the United States on August 11, 2024
Fit as intended, i feel they are a bit expensive for what they are. Will probably look into another homemade alternative in the future for different tools.
Dustin R Wyatt
Reviewed in the United States on July 21, 2024
Great for quick and easy use
Ray Wise
Reviewed in the United States on September 11, 2023
I used it anyway but had to modify/enlarge holes on the rubber clamp to accommodate mounting hardware and screws. Hardware should be included in clamp set. Good quality of parts just not compatible without altering.
A. Thomas
Reviewed in the United States on December 6, 2023
Well made though overpriced IMHO. I was able to use. For anyone considering the screws provided are too large for the rubber clamp holes, however, drilling or reaming out is not required. Simply start screwing through the rubber hole until through the far side and then screw together. My challenge was mounting to the molle rack which was mounted to the car already so had a tight space. Again, I recommend this product and seller though a little overpriced. I used with a Caliraised LED Molle panel.
Recommended Products

$24.71

$ 10 .99 $10.99

4.8
Select Option