Your cart is empty.
Your cart is empty.Product Description
Larry Hoerst
Reviewed in the United States on January 21, 2025
length ease of use
George Johnson
Reviewed in the United States on August 2, 2024
Not cheap looking.
Robert Republican
Reviewed in the United States on March 24, 2024
Great product, use them at work often, great for the home mechanic. Test your wires without cutting thru them snd having to re tape them and leave it vulnerable for shorts later on. A true time saver around the shop.
Consumer reporter
Reviewed in the United States on February 24, 2024
Looked for something like this for years. First set I was unable to figure it out as there are no directions. To me this was a new tool. It really does make a tiny pin prick in a wire and with an assistant you can label which wire controls the turn signals and the brake light and the flashers or any other wire you need to connect. If you are concverned about a pin prick in a wire get a bottle of plastic coat that makes a seal on the wire you just pin-pricked to identity its function or you can put a small piece of tape or use that spot to attach a T-Connector to. (Most wiring people will know what that is.).
BBM
Reviewed in the United States on December 5, 2024
OKBut wish they were a bit thicker for they tend to slip out of my fat hands.suggestion - make the tips thin and the handles thicker/beefier.
Adrien Joinette
Reviewed in Canada on November 11, 2024
Excellent quality worked better than expected
Customer
Reviewed in Canada on October 29, 2024
Serve there purpose worked well for my project. Glad to have them.
William Coopy
Reviewed in the United States on October 16, 2024
Cost effective
Dave
Reviewed in Canada on July 13, 2023
They work just fine.
CREEK MAN
Reviewed in the United States on February 12, 2023
This product is cheap but still works well. My real beef is their no directions. The piercing pin is set as if it were already in the diagnostic position, so common sense says pull up to retract the pin. I pulled the handle of the body, and fortunately, I was able to re-install it. So to retract the pin you push down on the "T" handle.Now inside the "T" handle is a spring or other part to possibly receive a multimeter probe? The point to this a scrap of paper with directions would be helpful. The vendor might consider not everyone knows how this tool works. But it's a whole better than sticking pins into the wire, and just before your set the pin falls out... For the money an occasional use it's a good deal.
Fred Bloggs
Reviewed in the United States on December 28, 2023
Just push down on the spring loaded part and pull up to puncture the insulation. Although I am loathe to damage any insulation, just two wraps with electrical tape and it is as good as new.It;s nice that my multimeter probes fit these probe holes perfectly.The black one is great for checking resistance to ground (Bad grounds) and the red one is good for any positive voltage signal.
Francisco Canchola
Reviewed in Mexico on December 13, 2023
Buen producto muy necesario para no estar pelando los cables automotrices durante las pruebas de continuidad y voltaje.
Joel Catalán Martínez
Reviewed in Mexico on October 18, 2023
Muy practico y se buena calidad
Recommended Products
$649.00
$ 99 .00 $99.00