Shopping Cart

Your cart is empty.

Your cart is empty.

PROVerXL 4030 Threaded Inserts MDF Spoilboard

4.8 (2) Write Review
Free shipping on orders over $29.99

$40.62

$ 17 .99 $17.99

In Stock

About this item

  • Material: MDF (Medium-Density Fibreboard). MDF is very dense translating into more weight with enhanced strength and durability. Size is 512 x 400 x 15mm ( 20.2” x 15.7” x 0.6”)
  • The flat and smooth surface can ensure the stability of the cutting material, easy to resurface.
  • Perfectly compatible with Genmitsu PROVerXL 4030 CNC router kit.
  • Pre installed threaded inserts for your clamps and fixtures. Easy to install the spoilboard with pre drilled holes.
  • We recommend keeping a spare spoilboard so you’re not stuck if the one you’re using gets damaged.


Product Description

1
4

Installation Guide

1. Loosen the screws on the original spoilboard and each dust baffle; remove the original spoilboard

2. Position the new MDF spoilboard on the PROVerXL Base and align each Dust Baffle to the side of the spoilboard. Align with the screw holes and tighten down with the M5 x 16mm screws.

3. Align the MDF spoilboard with the screw holes at the front and back of the machine. Be sure the board is right side up (Threaded Inserts should be towards the bottom. If you install it in reverse the mounting screws will protrude from the top of the spoil board). Tighten with M5 x 20mm crews.


MG
Reviewed in the United States on November 21, 2024
My husband wanted this but unfortunately it arrived damaged and had to be returned. My husband said it would make a good base but not a good spoil board on his machine since there are threaded inserts that could cause damage to a bit if accidentally hitting it, so something to be aware of if you intend to use it as a spoil board.
Joel G.
Reviewed in the United States on March 8, 2021
Mostly good fit, though a couple of the screw holes are slightly out of alignment. Otherwise a good product.