Your cart is empty.
Your cart is empty.Polyurethane based suspension, driveline and chassis components have been designed as an upgrade to the soft factory rubber components.
J.R.
Reviewed in the United States on June 26, 2024
I expected this to be of comparable durometer to the rest of the prothane bushings I bought for my front upper and lower control arms, but the lower bushings in this kit are rock solid with absolutely no give. If you tap them against each other it sounds like smacking Legos together. I'm a bit concerned about potential side loading on the strut shaft due to how hard they are as the suspension moves through its range. It could potentially cause premature shock failure. Would have been better if the lca bushings in the other kit were made of this stiffness, and the shock bushings made of the softer durometer that the lca bushings are made of
Marcos
Reviewed in the United States on March 27, 2024
Supera los standares del oem
Juan marron
Reviewed in the United States on September 29, 2020
Got what was pictured, fit perfectly
caleb andersen
Reviewed in the United States on December 22, 2019
Box has the right sticker on it but the contents is not the right bushings for the car
pamela flores
Reviewed in the United States on September 17, 2018
THEY GOT THE JOB DONE
N2DEEP
Reviewed in the United States on May 10, 2012
Aaaaagh sums it up. My og ES set finally started to wear out in the center. Apparently these go bad too over a longer time then og rubber. With that being sad, don't think you do these once, drive 160,000+ miles on them and assume you can get another 160,000 on them. AINT happening. Not with these MI roads at least. Pothole State. lol
Recommended Products
