Your cart is empty.
Your cart is empty. * Durable Urethane and Metal Construction
* For Street or Competition Use
* Hardware Included
* Made in USA
Jon Cantin
Reviewed in the United States on June 2, 2020
These are well made motor mounts.
MMC CLUTCHES
Reviewed in the United States on March 29, 2020
I liked the design and fitment of this product but upon installation stud came out. Did not snap just pulled out looks pressed in not welded in very poor quality unless i just got a defect
Customer
Reviewed in the United States on March 2, 2020
Cant go wrong with something that's fits perfectly while looking clean
rc
Reviewed in the United States on January 3, 2020
Fit well on a 1993 Fox Mustang 5.0L motor as it should.
Trent R
Reviewed in the United States on September 1, 2019
As close to solid as you can get and I don’t notice any engine vibrations even after replacing 30 year old almost non existent mounts.
JamesPNW
Reviewed in the United States on May 1, 2019
I bought a parts store replacement set... They didn't even bolt up to the block I spent an hour fitting them and they where terrible engine flopped around under load. Bought these and the fit perfectly engine is snugly held into place .
ROB
Reviewed in the United States on July 18, 2018
These mounts fit perfect in my 1988 mustang GT. No modifications were necessary but it took a little finesse to get them in due to limited space. My original mounts were pretty much spent and i was getting some vibration so i got these. Very smooth with no vibration like factory rubber mounts but will last a lifetime. They are very strong and built like a tank. I also have used prothane on other cars with excellent results.
Always in the Woods
Reviewed in the United States on December 5, 2017
Don't bother with parts store replacements. these are quality made, fit perfect, and perform great. They'll also last you almost forever.
Recommended Products
