Your cart is empty.
Your cart is empty.Product Description
Our Bike Wall Mount is Made of High Quality Strong Steel and Scratch-Proof Coating.
TPR Rubber Arm Cradles
Length Adjustable Beam
Adjustable Arm Up to 88 Degrees
Highly Adjustable Arms and Hanger Beam Allow for Different Bike Frame.
Angelika
Reviewed in Poland on March 3, 2025
bardzo dobry uchwyt, super jakość
LNehl
Reviewed in the United States on January 4, 2025
These are great bike racks for our garage. They keep our bikes up and out of the way while saving space. These racks make our bikes more available to be able to reach verse being in a shed. Definitely recommend these to any cyclists looking for a rack that is strong, easy to pu lt up and allows your bike to be out of the way.
Kbn
Reviewed in the United States on January 27, 2025
The rack works great for my 23lb road bike. The instructions were clear and straightforward. The adjustable arms are convenient for maximum stability.
AKD
Reviewed in the United Kingdom on January 27, 2025
Really well made item with simple instructions.Holds my 11kg bicycle without any problems
arnaud moreau
Reviewed in France on January 19, 2025
conforme au descriptif, simple d'installation !! je recommande
Customer
Reviewed in the United States on January 13, 2025
For a lightweight roadbike, but this could easily hold 3x the weight
zolo
Reviewed in the United States on September 8, 2024
Well made, easy to mount into a stud with the provided screws. Rubberized arms hold the bike securely without marring the finish. With the bike level the front wheel doesn’t move so no need to use the included wheel bungie. The bungie quality does seem fine though, nothing special but it works. Not sure why others had an issue - maybe pulling it too tight. I’ll probably but another to hang my other bike above the first one.
MartinKPunkt
Reviewed in Germany on December 29, 2024
Verwende sie für ein Cowboy Classic mit 22kg Gesamtgewicht. Würde sie wieder kaufen. Warum rot teurer ist als schwarz weiß ich allerdings nicht. Sieht jedenfalls schick aus.
SS
Reviewed in the United States on December 19, 2024
Love these bike racks. I purchased two and will need a third. Super easy to mount on the wall. The only help I needed was lifting the bike to place on the rack. Only three screws to insert into the stud. A tap tap then screw into the stud. You will not regret this purchase.
Michael
Reviewed in the United States on January 27, 2024
I've been using this for about two months now. This helped me save space in my 1-car garage as I was able to lift it up near the roof and fit a ton of stacking bins and toolboxes underneath.The construction is sturdy, just make sure you screw into a stud, I don't know why they would ever include plastic wall anchors. Don't try it, I guarantee they will fall out of the wall very quickly.
escbuyer
Reviewed in Mexico on June 27, 2023
Buen diseño, buena calidad de ferretería para su instalación, 4 estrellas por que me hubiera gustado que tenga una argolla para instalar un candado
R. Pagni
Reviewed in the United States on January 12, 2021
This is a great bike storage system, highly recommend. Ok, enough about how great it is. For me, I want to know tips how to install it and you probably do too. As you can see, I installed 3 holders. First step was to find the studs behind the sheet rock. I used a quality stud finder but to double check the studs exact location I used a finishing nail and hammer to find the exact sides of the stud. Glad I did because some of the stud finders locations for the center of the stud were not right.You can use longer screws than those that come with the kit (3) and mount the 3 holes of the bracket into one stud. I read where some have said this works. Didn’t seem it would be real stable so I decided to mount a 2x6 across two studs. A 2x4 is not wide enough for the bracket. I cut the 2x6’s 22” long so they overlapped the end of each stud by 3”. I attached the 2x6’s to the studs using 5/16 x 4” lag screws. I used 4 lag screws per 2x6, two on each end.You’ll need a impact driver to get the lag screws thru the board and into the stud. A regular drill won’t do it. If you don’t have an impact driver you could always muscle a socket wrench. After I drove the lag screws in as far as they would go I did have to use a socket (1/2 for the 5/16 lag screw) to finish tightening them down.I measured the bikes with the holder/ bracket to get the spacing between bikes. My measurements resulted in a spacing of 40” from the top of one board to the top of next board. For my bikes it was perfect. Your bikes may require different spacing.These type of wall mounts are perfect. Unlike other systems that are one position, usually horizontal, these allow you to adjust the arms to fit the different types of cross members as not all bikes are alike. They’re pricey, but I think they’re well worth the money. The 2x6x8 was $12.00 and the 12 lag screws were $9.00.I hope this helps if you decide to purchase these.
ObjectiveReviewer
Reviewed in the United States on August 27, 2020
My bicycle weighs around 30 pounds and the small screws provided by the company do not appear to provide adequate support. I purchased 2 Structural lag screws for a couple of dollars (3 1/2 in. long, 5/16 in. diameter). I had to drill the holes bigger for the screws to fit through the opening. I installed on drywall, but used a stud finder to make sure I hit a stud when I drilled the holes. Mark the wall with a pencil and then drill holes slightly smaller than the screws. The strap to hold the front wheel from turning is a piece of crap and broke the first time I tried to use it. So I do not use a strap although I could possibly use a bungy cord. I just stabilize the bike by having the handle grip against the wall as shown in the last pic. This bike holder serves the purpose after my modifications, but it is not worth the money for what you get. It should be priced around $20-25.08/31/2020 I am updating my review to 4 stars due to the exceptional customer support. I emailed customer support due to the strap that broke on the first use. They are not only sending me a new one from Great Britain, but also, they credited my charge card for $10.00! And there response was in a timely manner as well.
Recommended Products
$39.99
$ 19 .99 $19.99