Your cart is empty.
Your cart is empty.3.5 out of 5 stars
Introduction
SmaringWing TP101 smart tank chassis tracked robot chassis remote control platform for Arduino, Raspberry pi, NodeMCU. Perfect for DIY projects, robotics learning, STEAM education, teaching and competitions.
Many schools or education departments choose this robot car chassis learning kit to let school teens learn more about AI robot knowledge. Having teens learn how to build and program fully functional robots, improves their logical thinking, mechanical and electrical abilities. The surface of the robot chassis is sandblasted and oxidized, and the bearing wheels are made of high-quality engineering plastics, which are robust.
Product Parameter:
- Material: Plastic
- Product Type: TP101 Robot Chassis
- Product Size: 7.6*6.42*2.36 in / 19.3*16.3*6 cm (Length*Width*Height)
- Product Weight: 0.47kg / 1.04lb
- Panel Material: 2mm aluminum
- Surface Treatment: Sandblasting oxidation
Driving Wheel Parameter:
- Color: Grey
- Aperture: M3
- Size: 50*33 mm
- Inner Diameter: 4/5/6 mm (coupling)
- Material: Plastic
- Type: with connectors
Bearing Wheel Parameter:
- Material: Plastic
- Color: Silver
- Aperture: M4
- Size: 50*35 mm
Motor Paramters:
- Voltage Range: 6v-12v
- No-Load Speed: 170-350rpm
- Rated Voltage: DC 12V
- No-Load Current: 100mA
- Motor Weight: 100g
Tracks Parameter:
- Material: Engineering plastic
- Color: Black
- Connection: The track is connect one section by one section.
- Length: The length of track can be changed as any length
Package Included:
- 2 pcs Tracks
- 2 pcs Driving Wheel
- 2 pcs Bearing wheel (5mm inner size)
- 2 pcs DC Motor
- 1 set Screw accessories & hexagon wrench
D. Yost
Reviewed in the United States on December 18, 2023
Been running on 3S 4500 and 4S 2200 Lipos, using L298 motor driver I and am enjoying the toying/testing on carpet. The motors have not gotten hot, only slightly warm thus far. Considering plugging in a 6S and checking/monitoring heat levels.Pay attention to instructions regarding removing track sections, the track pin is made to be removed from one direction only, and there is a brass tool in kit that works great.I needed to disassemble multiple times to figure out that I should have inspected better prior to initial assembly because there lacks details in assembly instructions.The hole in frame which the hex-head shaft is mounted is much larger than I would have expected and this caused confusion. I believe the "bearing shaft" should be held with nuts and washers through the hole that is large otherwise the tracks will not align vertically/horizontally depending.First assembly I mounted hex-head shaft in wrong location/hole through frame which caused the tracks to not extend the front and rear of frame evenly/symmetrically. Second assembly I again used incorrect mounting location/hole through frame and the track were not vertically symmetric/even. (I think the tracks were symmetric/even front to back but not up and down, I think cannot recall exactly).
Recommended Products
