Shopping Cart

Your cart is empty.

Your cart is empty.

Polytek Pol-Ease 2500 Release Agent (Case of 12 cans)

5.0 Write Review
Free shipping on orders over $29.99

$195.00

$ 86 .99 $86.99

In Stock
  • Can be washed off models and castings if they need to be painted
  • For Mold Making: Apply to non-porous or sealed models when making silicone rubber molds (not recommended for use with liquid polyurethane rubbers).
  • Apply to silicone rubber molds when casting liquid silicone rubber
  • To extend mold life, apply to silicone molds when casting materials such as polyurethane plastics, rubbers or epoxies (release agent is not needed for this process, but can extend mold life)
  • Apply to polyurethane molds before casting polyurethane liquid plastics


Molds will not last as long as they would if Pol-Ease 2300 Release Agent was used. The main reason for using Pol-Ease 2500 in a polyurethane mold would be to cast a part that can be cleaned more easily than a part covered with Pol-Ease 2300. This is beneficial when painting cast parts. After spraying, brush out this release agent with a soft brush to help improve results. No drying time necessary.