Your cart is empty.
Your cart is empty.Not bright enough
Reviewed in the United States on March 7, 2025
Look and work good
Cj
Reviewed in the United States on January 30, 2025
These don't perfectly fit. The hold are off by .5-1 in. So mine cracked a bit to fit
Carver
Reviewed in the United States on January 11, 2025
Products fit great. Only issue was first set of lights came in wrong but they shipped another one pretty fast.
Cheryl A.
Reviewed in the United States on June 21, 2024
Very way to install. Now I can see clearly again as the original headlight were so clouded over.I would recommend to anyone needing repalement headlights.
Matt Knowlton
Reviewed in the United States on December 31, 2024
Very nice though I ordered the wrong ones. Return went smoothly and I ordered the correct ones. Very happy with the complete transaction.
Jb
Reviewed in the United States on December 24, 2024
Product fit like factory perfect fit nd nice upgrade to my 98 truck
Mason
Reviewed in the United States on December 17, 2024
Damaged in shipping, reached out to seller, never heard back from them, extremely cheap, but fit and do light things
MonStrasity
Reviewed in the United States on April 12, 2022
I never write reviews but after what I went through to get these installed, I felt compelled to help future installers. First, I will say that once I got these on, they seemed pretty good for the money I paid for them but getting to the finished state was a challenge.There are no installation instructions included with these and YouTube was not a huge help. I can say that your bolts all are 10mm with a T30 torx in the center so either will work. Don't lose your bolts because these don't come with replacements. The first two bolts are easy to find, the third is between the bumper and the headlight at the lower rear of the assembly.The first issue I came across was that the teeth on the blinker bulb plug do not match the new headlamp assembly. The cutouts are not in the right place. I was able to widen one of the smaller cutouts with an exacto knife and then I was able to fit it in. The plastic is fairly soft which is probably not a good thing but helped here.The second issue, still with the blinker bulb plug, is that it doesn't fit snug at all, and it can freely rotate because there is nothing that stops it. If you leave it as is, it will definitely fall out as you drive. And this had nothing to do with the cut I made earlier; the plastic of the new fixture is just thinner. I solved this by 3D-printing a soft rubber gasket (1.7mm thick out of TPU). I think you could probably fashion some gaskets out of heavy paper or light cardboard. Mine was thick enough that it held the blinker tightly in place with no worry that it will ever twist out.The third issue has to do with the picture I uploaded. There is an insert stuck on the new fixture that your truck already has installed. If you force it all together, the light will stick out from the truck a good half an inch (like other reviewers have said). You either need to remove the insert from your truck (very difficult) or remove the insert off of the new fixture (less difficult). I did each side differently and they both worked out fine. After you remove one or the other, the fixture should pop in without a lot of trouble.
Recommended Products