Your cart is empty.
Your cart is empty.Fusible Link wire is designed to open a circuit when an extreme overload occurs. Replacement links should be used only to repair factory installed fusible links with the original length and gauge being matched exactly. Typically, fusible link should be 4 gauges smaller than the circuit wire. **CAUTION:**Do not substitute ordinary wire for fusible links and do not replace fuses with fusible link wire as highly technical calculations are needed to determine the correct length and gauge of the fusible link.
Joel P.
Reviewed in the United States on July 7, 2024
Completed my wiring on a CJ HEI project. Perfect fit!
tombest
Reviewed in Canada on April 18, 2024
its fine not sure if it will work yet
Jose Rocha
Reviewed in the United States on April 14, 2024
Item was as described. Used it right away and provided the proper protection for my circuit. Easy to install.
patrick h plemel
Reviewed in Canada on June 26, 2022
Excellent package to hand on hand for those hard to find replacement fusible links
MTshoehorse
Reviewed in the United States on June 15, 2021
Initial impressions are very good. This is a 12 gauge fusible link. I’m using it to protect 8 gauge wire. I can’t tell you if it will work long term but I expect it will. It didn’t burn up when I initially hooked it up which means I didn’t screw up my wiring and it’s not undersized. I’m not going to test it at an overload situation so I’ll trust that it would save my car in the event of a dead short or an over amperage situation between my battery and alternator. It’s for sure better than what I had before which is nothing with regards to protection. It seems high quality product and there’s plenty left over where I can build up some spare links for backups or other projects.
Sam Jeffords
Reviewed in the United States on April 28, 2021
It worked as designed.
Ashley B.
Reviewed in the United States on September 20, 2020
Nice length to cut down for multiple uses from the small roll. Used 4-5" inches, 4 wire sizes down from gauge of protected wire. In other words this 12 gauge size would be used as short circuit protection of 8 gauge wiring. Crimp connectors on each end, and solder. Leave outside of any wire covering.
Greg
Reviewed in the United States on February 6, 2020
Just what I needed.
Glenn Campbell Jr.
Reviewed in the United States on June 15, 2016
Used on my '57 Chevy new wiring harness to the 8 gauge supply wire. Used crimp on connections with heat shrink and it worked great. Appears to be well made.
RED ROCKER
Reviewed in the United States on May 1, 2013
So far so good. It hasn't 'blown' yet but the quality feels nice and installs just like a piece of wire. I got 5 pieces and not a roll as it's described now, I got the same color shown in the pic (turquoise) and shipping was quick. I use it connected straight to my one wire 140 amp powermaster alternator on a 355 small block.
Recommended Products
$11.41
$ 5 .99 $5.99